PLATE 3146116 - Caterpillar

Access the Cat Factory Password System (FPS) at https://fps.cat.com.
Enter the required information.
Obtain the passwords and enter into the appropriate input boxes labeled "Factory Password #1" and "Factory Password #2".
Turn the start key to the OFF position and wait at least 15 seconds. Turn the start key back to the ON position. Note: The new feature will be activated on the next power cycle.
In the configuration screen, double click on the "Work Tool Self Level System Installation Status". Ensure that the feature is set to "Installed".
Illustration 28 g03875583
In the configuration screen, double click on the "Lift Linkage Sensor Configuration" ink.
Illustration 29 g03875589
In the Pop-up window, select "Rotary Position Sensor" and click "Yes". Note: The new feature will be activated on the next power cycle.RTD (Return to Dig) Machine Configuration (Optional)
The 421-0122 Work Tool Positioner Kit can also be configured for the RTD (Return to Dig) feature by using Cat® Electronic Technician (Cat ET) Service Tool. This feature consists of two additional modes. "Work Tool Positioner Mode" enables the work tool to return automatically to an operator selectable preset angle. "Return to Dig" enables the work tool to return automatically to an operator selectable preset angle and automatically lowers the lift arms to the stops. Refer to the Operation and Maintenance Manual for your machine for more information on using these modes.
Connect the Cat ® Electronic Technician (Cat ET) Service Tool to the machine. Turn the start key to the ON position. Do not start the engine.
Illustration 30 g03875565
Start the Cat ET and select the Machine ECM.
Illustration 31 g03875573
From the menu select "Service", then "Configuration".
Illustration 32 g03875601
In the configuration screen, double click on the "Return to Dig Feature Installation Status" link.
Illustration 33 g03875605
5. In the pop-up window, change the new value field to "Installed". Click "OK".
Illustration 34 g03875578
Access the Cat Factory Password System (FPS) at https://fps.cat.com.
Enter the required information.
Obtain the passwords and enter into the appropriate input boxes labeled "Factory Password #1" and "Factory Password #2".
Turn the start key to the OFF position and wait at least 15 seconds. Turn the start key back to the ON position. Note: The new feature will be activated on the next power cycle.
From the menu select "Service", then "Configuration".
In the configuration screen, double click on the "Return to Dig Feature Installation Status". Ensure that the feature is set to "Installed".Machine Calibration
Connect the Cat ® Electronic Technician (Cat ET) Service Tool to the machine. Turn the start key to the ON position. Do not start the engine.
Illustration 35 g03875565
Start the Cat ET and select the Machine ECM.
Illustration 36 g03875644
From the menu select "Service", then "Calibration".
Illustration 37 g03875646
Ensure no one will cross the path of the machine as the lift arms will move during the calibration. Follow the instructions to initiate the calibration, hitting "Next" as each condition is satisfied. As the last step suggests, move the lever to the raise position to begin the automated calibration. This calibration process takes approximately 5 to 10 minutes.Note: The new feature will be activated on the next power cycle.