PLATE 3153179 - Caterpillar

Machine Stopping
Park on a level surface. If it is necessary to park on a grade, block the wheels securely.Do not engage the parking brake while the machine is moving unless an emergency exists.
1. Apply the service brakes to stop the machine. 2. Move the transmission control lever into NEUTRAL. 3. Engage the parking brake.4. Lower the attachments to the ground and apply slight down pressure.Engine Stopping
Stopping the engine immediately after it has been working under load, can result in overheating and accelerated wear of the engine components.Refer to the following stopping procedure, to allow the engine to cool, and to prevent excessive temperatures in the turbocharger center housing, (if equipped) which could cause oil coking problems.
1. With the machine stopped, run the engine for five minutes at LOW IDLE. Stopping the engine immediately after it has been working under load, can result in overheating and accelerated wear of the engine components. 2. Turn the start switch key to OFF. Remove the key.Leaving the Machine
1. Use the steps and handholds, use both hands and face the machine, when dismounting. 2. Inspect the engine compartment for debris. Clean out any debris and paper to avoid a fire.3. Remove all flammable debris from front bottom guard through the access doors to reduce fire hazard.4. If the machine is being parked for an extended period (overnight, etc.), turn the disconnect switch key to OFF and remove the key.5. Install all vandalism protection covers and locks.