PLATE 3157182 - Caterpillar

Table 2
Optional Tools (2)    
Tool    Part Number    Description    Qty    
D     8T-0855     Pressure Gauge
0 to 4000 kPa (0 to 580 psi)     1    
E     030-7262     Pressure Gauge     1    
( 2 ) The Optional tools can be used in place of the digital pressure measurement tools which are specified in the Required Tool list
Drive the machine to a smooth, horizontal surface.
Illustration 1 g02545246
Move propel lever (1) to the NEUTRAL position.
Rotate speed dial (4) to the MINIMUM position.
Move parking brake switch (2) to the ON position.
Move propel mode switch (3) to the PAVE position.Note: The machine must be in PAVE mode in order to operate the screed lift system.
Illustration 2 g02545258
Move screed lift switch (5) to the FLOAT position. Lower the screed to the ground.Note: The screed lift switch on the inactive instrument panel must also be in the FLOAT position in order to lower the screed.
Illustration 3 g02545264
Move throttle control switch (6) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
Illustration 4 g02545267
After the engine reaches low idle, move