PLATE AS 3157193 - Caterpillar

Press OK key (10) to begin the calibration.
Illustration 10 g02512418
Move parking brake switch (2) to the ON position.
Rotate speed dial (4) to the mid range position.
Confirm propel mode switch (3) is in the PAVE position.
Move propel lever (1) to the NEUTRAL position.
Press OK key (10) .Note: If the display does not advance after pressing the OK key, observe the display and ensure that all required conditions are met.
Illustration 11 g02512420
Note: An operator message will be displayed informing the operator that the machine will move at a high rate of speed and to allow adequate space during this step.
Move parking brake switch (2) to the OFF position.Note: The parking brake switch on both instrument panels must be in the OFF position in order for the machine to move.
Illustration 12 g02512459
Squeeze trigger (11) and move propel lever (1) to the FULL REVERSE position.
Press OK key (10) .Note: If the display does not advance after pressing the OK key, observe the display and ensure that all required conditions are met.
Illustration 13 g02512462
Display should read "Calibrating speed sensors".Note: Observe the display. When the speed sensors have been calibrated, the display will prompt the operator to move the propel lever to the NEUTRAL position.
Illustration 14 g02512463
Move propel lever (1) to the NEUTRAL position.
Illustration 15 g02512464
Squeeze trigger (11) and move propel lever (1) to the FULL REVERSE position.
Illustration 16 g02512476
Display should read "Calibrating initial current for reverse pumps".Note: At this point, the system is performing the coarse calibration of the initial current for the propel pumps.
Illustration 17 g02512480
Move propel lever (1) to the NEUTRAL position.
Illustration 18 g02512483
Squeeze trigger (11) and move propel lever (1) to the FULL REVERSE position.
Illustration 19 g02512538
Display should read "Calibrating initial current for reverse pumps".Note: At this point, the system is performing the fine calibration of the initial current for the propel pumps.
Illustration 20 g02512541
Move propel lever (1) to the NEUTRAL position.
Illustration 21 g02512544
The display should now read "CALIBRATION COMPLETE". Push back key (12) to return to calibration screen.
Push home key (8) to exit the calibration screen.
Move parking brake switch (2) to the ON position.
Move throttle control switch (7) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
Illustration 22 g02512549
After the engine reaches low idle, move engine start switch (13) to the OFF position.