PLATE AS 3167914 - Caterpillar

Disassembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-2320 Combination Puller 1
8B-7560 Step Plate 1
B 1P-0529 Handle 1
1P-0468 Drive Plate 1
1P-0465 Drive Plate 1
C 1P-0462 Drive Plate 1
1P-0461 Drive Plate 1
1P-0529 Handle 1 Start By:
Remove the engine oil pump.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01939556
Remove bolts (2), locknut (1), and suction bell (3).
Illustration 2 g01939557
Remove idler gear (4).
Use Tooling (B) in order to remove the bearing from idler gear (4).
Remove bolt (7) and washer (6) from drive gear (5).
Use Tooling (A) in order to remove drive gear (5) from the shaft.
Illustration 3 g01939558
Remove bolts (16), bolt (12), cover (11), and O-ring seal (15) from pump body (8).
Remove shaft assembly (9) and shaft assembly (10) from pump body (8).
Remove bolt (14) and pressure relief valve (13).
Illustration 4 g01940293
Remove bearings (17) from cover (11).
Illustration 5 g01940294
Use Tooling (C) in order to remove bearings (18) from pump body (8).