PLATE 3220118 - Caterpillar

Illustration 8 g01372256
Hot parts or hot components can cause burns or personal injury. Do not allow hot parts or components to contact your skin. Use protective clothing or protective equipment to protect your skin.
Pin Lock (6)This safety message is located near the hopper support pins. This safety message is also located near the screed travel lock pins.
Illustration 9 g01372258
Raised hopper wings can unexpectedly swing down and cause a crushing hazard which could result in serious injury or death. Always engage the hopper travel locks in order to secure the hopper in the raised position. Refer to Operation and Maintenance Manual, "Hopper Travel Lock" for directions on engaging the hopper travel lock.
Shock Hazard (7)This safety message is located near the generator.
Illustration 10 g03515558
Shock/Electrocution Hazard! Do not work on this equipment unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in serious injury or death.
Jump Start Cables (8)This safety message is located on the battery locking clamp.
Illustration 11 g01370909
Explosion Hazard! Improper jumper cable connections can cause an explosion resulting in serious injury or death. Batteries may be located in separate compartments. Refer to the Operation and Maintenance Manual for the correct jump starting procedure.
Product Link (9)This safety message is located on the operators platform near the exhaust stack.
Illustration 12 g01370917
This machine is equipped with a Caterpillar Product Link communication device. When electric detonators are used, this communication device should be deactivated within 12 m (40 ft) of a blast site for satellite-based systems and within 3 m (10 ft) of a blast site for cellular based systems, or within the distance mandated under applicable legal requirements. Failure to do so could cause interference with blasting operations and result in serious injury or death.In cases where the type of Product Link module cannot be identified, Caterpillar recommends that the device be disabled no less than 12 m (40 ft) from the blast perimeter.
High Pressure Spray (10)This safety message is located on both sides of the rear of the machine, near the hydraulic hoses connected between the asphalt paver and the asphalt screed.
Illustration 13 g03322115
Fluid under pressure, stay back while the machine is in operation. Risk of high-pressure fluid spray may cause serious personal injury or death.
Entanglement (11)This safety message is located on both sides of the rear of the machine, near the external side of the auger.
Illustration 14 g01372260
Stay clear of the work tool during operation. Entanglement could result in personal injury or death.