PLATE 3304316 - Caterpillar

Illustration 1 g00510753
There are four O-ring plugs which need to be tightened to the following torque. ... 5 1 N m (44 9 lb in)
Two O-ring plugs that are on the engine side of the fuel injection pump housing
One O-ring plug that is on the engine side of the fuel injection pump
One O-ring plug that is on the governor side of the fuel injection pump (1) Distance from the end of the dowel to the opposite wall of the bore ... 40.40 0.18 mm (1.591 .007 inch) (2) Dowel (3) Distance from the flat surface on the rack bearing to the opposite inner bearing bore after installation ... 11.178 0.050 mm (.4401 .0020 inch) (4) Rack bearing (5) Install the bearing with the flat surface at the following angle. ... 15 degreesNote: The 6V-4824 Rack Bearing Driver and the 6V-4825 Guide Plate are available to install the rack bearing to the correct angle and depth.
Illustration 2 g00510754
(6) Distance from the end of the pin to the opposite wall of the bore ... 35.57 0.10 mm (1.400 .004 inch) (7) Distance from the governor end of the housing to the end of the dowel ... 7.5 0.5 mm (.30 .02 inch) (8) Location of rack bearing Distance from the drive end housing face to the drive end rack bearing ... 83.0 0.5 mm (3.27 .02 inch) Inside diameter of the bearing after assembly ... 12.767 0.058 mm (.5026 .0023 inch) (9) Location of rack bearing Distance from the governor end housing face to the governor end rack bearing ... 6.5 0.13 mm (.256 .005 inch) Inside diameter of bearing after assembly ... 12.746 0.045 mm (.5018 .0018 inch) (10) Position of the oil supply hole for the three camshaft bearings ... 30 3 degrees (11) Inside diameter of the three bearings for the fuel pump camshaft after assembly ... 74.089 0.039 mm (2.9169 .0015 inch) (12) Distance from the surface of the bore to the end of the camshaft bearing ... 1.0 0.5 mm (.04 .02 inch) (13) Distance from the surface of bore to the end of center camshaft bearing ... 218.0 0.3 mm (8.58 .01 inch) (14) Distance from the governor end of the housing to the end of the camshaft bearing ... 1.00 0.25 mm (.039 .010 inch)