PLATE AS 3406848 - Caterpillar

Illustration 6 g00695867
Attach an appropriate nylon lifting sling and a suitable lifting device to the head of pin (9) and to the tail end of the pin. Lift the pin into position on the work tool. The weight of the pin is 65 kg (143 lb). Align the pin with the stops that are welded to the crushing arm. Apply 4C-5598 High Temperature Anti-Seize to the pin. Coat the threads and the smooth surface of the pin. Use a large hammer and brass drift to partially install the pin.Note: The tapered side of spacers (16) must face the cylinder.
Place two spacers (16) into position next to cylinder (15). Align the spacers, the cylinder, and the pin.
Continue to install pin (9) until cylinder (15) is secure. Ensure that the pin will not prevent the remaining cylinder from being installed. Remove the lifting slings and the lifting device from the pin after the pin is secure.
Remove the lifting sling and the hoist from the cylinder.
Illustration 7 g00695810
Typical example
Attach the nylon lifting sling and the hoist to cylinder (6). Lift the cylinder into position in the work tool. Refer to Step 5 for the weight of each cylinder.
Illustration 8 g00688629
Note: The tapered side of spacers (14) must face the cylinder.
Place two spacers (14) into position next to cylinder (15). Align the spacers, the cylinder, and the pin.
Illustration 9 g00681358
Typical example
Illustration 10 g00694606
Typical exampleThis photograph shows the proper alignment of the pin.
Complete the installation of pin (13) until the pin is flush with the stops.
Illustration 11 g00681356
Typical example
Install plate (12) to the pin. Use Tooling (A) to tighten the plate. After you tighten the plate, back off the plate until the nearest set of holes are aligned. Install two bolts (11) that secure the plate to the lower housing.
Illustration 12 g00688624
Note: The tapered side of spacers (16) must face the cylinder.
Place two spacers (10) into position next to cylinder (6). Align the spacers, the cylinder, and the pin.
Illustration 13 g00681342
Typical example
Complete the installation of pin (9) until the pin is flush with the stops.
Illustration 14 g00683726
Typical example
Install plate (8) to the pin. Use Tooling (A) to tighten the plate. After you tighten the plate, back off the plate until the nearest set of holes are aligned. Install two bolts (7) that secure the plate to the crushing arm.
Illustration 15 g00684365
Install two hose assemblies (5) to the cylinders.
Install the two O-ring seals to two hose assemblies (4). Place the hose assemblies into position on the cylinders. Install the four half flanges, the eight bolts, and the washers that secure the hoses.
Install the two O-ring seals to two blocks (3). Place the blocks into position on the cylinders. Install the eight bolts and the washers that secure the blocks.
Illustration 16 g00689009
Lubricate each cylinder bearing with clean grease. Grease fittings are located at each end of the cylinders.
Illustration 17 g00679783
Typical example
Remove lock pin (2) .