PLATE 3500076 - Caterpillar

OIL PRESSURE CONTACTOR ADJUSTMENT
13. Set-for-start button. 14. Adjustment screw. 15. Spring. 16. Locknut. 17. Contact button.
WIRING CONNECTIONS (Micro Switch Type)
D. Terminal B (normally closed) connect rack solenoid or TS1-8. E. Terminal W (normally open), connect automatic start-stop TS1-1 (starter magnetic switch). F. Terminal R (common), connect battery or TS1-7.Shut-Off Valve (Water Temperature)
3J5389 Plug8B4509 Connector3B9388 Connector9M6543 Hose Assembly4D6949 Hose Assembly3B7764 Reducing Bushing Heat Sink See the topic Contactor Switch (Water Temperature) in TESTING AND ADJUSTING for instructions to make a heat sink.1. Remove oil lines.2. Remove shut-off valve and install the 3J5389 Plug.3. Install the oil lines using the bushing, hoses and connectors.
SHUT-OFF VALVE (WATER TEMPERATURE)4. Start the engine and let it run at low idle.5. Put the heat sink and the shut-off valve in water. Use a torch to make the water hot and by using a thermometer, take note of the temperature at which the engine stops. If engine does not stop, look for a defect in the contactor switch for oil pressure.6. Install a new valve if necessary.Enclosed Clutches
Clutch Adjustment
The clutch engagement lever pull adjustment establishes the clutch plate pressure. The proper clutch lever pull is indicated in the chart. The clutches use two types of adjustment lock pins. Pin (1) should be pushed in the adjusting ring rotated. Pin (2) should be pulled out and the ring rotated to adjust the clutch.
CLUTCH ADJUSTMENT
1. Lock pin (push in type to unlock). 2. Lock pin (pull out type to unlock).Assembly Adjustments
Tighten hub nut to torque of 30 lb. ft. (4,1 mkg) to remove all clearance between parts, then tighten additional amount as shown in chart. Clutch and Mounting Adjustment Check
At time of installation, check the flywheel and flywheel housing face and bore run out.Clutch Shaft Seal Wear Sleeve Installation
Clutches which have oil lubricated shaft bearings are equipped with oil seal wear sleeves (2) on the shaft. Install wear sleeves with guide assembly (1), part of 1P2410 Wear Sleeve Installation Tool Group. Be sure the sleeve contours blend in with the shoulder fillets (3) on the shaft.
WEAR SLEEVE INSTALLATION
1. Guide assembly. 2. Wear sleeve. 3. Shaft shoulder fillets.Shaft Bearing End Clearance
Tighten adjusting nut to remove all clearance and seat bearing cups. At this point shaft should turn with dry bearing at torque of 60 lb. in. (70,0 cm.kg) in addition to seal drag. Then back off the adjusting nut the number of notches indicated in the charts and install the lock. Drive the front bearing cup to the