PLATE AS 3582945 - Caterpillar

Table 1
Machine Codes    
Sales Model    Machine Code    
950G     13    
962G     14    
IT62G     17    
966G     20    
972G     21    Expected Result: The two-digit machine code that is shown should match the machine.Results:
OK - Monitoring machine code is correct. Proceed to Step 2.
NOT OK - Monitoring system harness code plug is not correct. Repair the harness code plug for the monitoring system or replace the harness code plug with the correct harness code plug. Refer to System Operation, Testing and Adjusting, SENR1394, "Caterpillar Monitoring System" for more information on the Caterpillar Monitoring System.
Check if the fault is still present.
Turn the key start switch and the disconnect switch to the OFF position. Clean the contacts of the harness connectors.
Reconnect all of the harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Enter the service mode (Mode 3) of the Caterpillar Monitoring System. Clear all inactive faults. The Caterpillar Electronic Technician (ET) may also be used to delete inactive faults.
Operate the machine in all speeds and in all directions.
Determine if the CID 0270 FMI 12 service code is present or if the fault is shown in the diagnostic message screen of the Caterpillar Electronic Technician (ET).Expected Result: The CID 0270 FMI 12 service code is not present.Results:
YES - The fault is no longer present. The initial fault was probably caused by a poor electrical connection or by a short at one of the harness connectors that was reconnected. Resume normal operation. STOP.
NO - The fault is still active. Either the machine harness has failed or the wrong machine monitoring system was installed. Repair the harness or the monitoring system. If necessary, replace the harness or the monitoring system.