PLATE-WEAR 3657426 - Caterpillar

calibration procedure with the 4C-8195 Control Service Tool and the Caterpillar Electronic Technician (ET) will follow the same strategy. A text message that is displayed in the ET will be displayed as a numerical code on the Caterpillar Monitoring System.The numerical code will use as many as six digits. The digits are divided into three fields with two digits in each field. The first two digits are the calibration submode. For example, _ _60 _ _ would be the calibration mode for the implement control levers. The next two digits represent the step in the calibration. The last two digits are reserved for error codes. The last two digits will be blank when there are no error codes.
Move away from other operating machines and away from personnel. Park the machine on a smooth, level surface. Lower the bucket and/or attachments to the ground. Stop the engine.
Connect the 4C-8195 Control Service Tool to the machine.
Start the machine.
Enter the implement calibration mode. Toggle and hold the "Mode" switch until -7- is shown on the display. Release the "Mode" switch when -7- is shown on the display.
Enter the submode for calibrating the lift linkage. Toggle the "Scroll" switch until _ _60 _ _ is shown on the display.
Toggle the "Clear" switch. The display should show 6001_ _.Note: If the parking brake is applied the display will show 6002_ _.
Set the parking brake.
Toggle the "Clear" switch. The display should show 6002_ _.
Raise the lift linkage fully.Note: Check the implement lockout switch if implements do not move.
Toggle the "Clear" switch. The display should show 6003_ _.
If 6003_ _ is shown on the display, toggle the "Clear" switch. The display should show 6004_ _.
Tilt back the bucket fully.
Toggle the "Clear" switch. The display should change in order to show 6005_ _.
Lower the lift linkage fully.
Toggle the "Clear" switch. The display should show 6006_ _.
Ensure that the lift cylinders bottom out.
Toggle the "Clear" switch. The display should show 6007_ _.
Verify that the calibration is successful. Toggle the "Clear" switch. The display should change in order to show 6008_ _.Note: When the display shows 6008_ _, the calibration procedure for the lift linkage position sensor is successful.
Toggle the "Scroll" switch in order to proceed to another calibration submode. Toggle the "Mode" switch in order to exit the calibration mode.