PLATE-WEAR 3691895 - Caterpillar

Illustration 1 g00984624
Turn switch (1) for the grade/slope control ON.Note: Allow the system to warm-up for a minimum of 15 minutes before calibrating any of the modes that are available in the grade/slope control.
Illustration 2 g00984682
(2) Switch for the mode scroll (3) Switch for MENU #1 (4) Left readout (5) Right readout (6) Switch for MENU #2 (7) Enter switch
Depress the switch for the mode scroll (2). Release the switch when "CALIBRT" is displayed on left readout (4). "MENU #1" will be flashing on right readout (5) .
Press and hold switch (3) until the desired submode is showing on right readout (5). The operator can choose from the following submodes: VALVE OFFSET, "SLOPE", "LEFT WAND" and "RIGHT WAND". Release switch (3) when the desired submode is displayed on left readout (4) .Left Wand Submode
Press and hold the switch for menu #1 (3) until "LEFTWAND" is displayed on right readout (5). Release the switch for menu #1 (3) when "LEFTWAND" is displayed. "CAL LWND" will then be displayed on left readout (4). "MENU #2" will then be displayed on right readout (5). This submode sets the maximum up end stop of the left grade position sensor. This submode will also set the maximum down end stop of the left grade position sensor.
Press and hold the switch for menu #2 (6)