PLATE AS 3732488 - Caterpillar

Machines that are equipped with a cab have a window wiper as standard equipment. The window wiper/washer switch is located in the rear of the cab on the left side.
Window Wiper - Push the switch to the middle position in order to turn on the wiper. Push the bottom of the switch in order to turn off the wiper.
If the washer is used continuously for more than 20 seconds or used when no washer solution comes out, motor failure can result.
Window Washer - Push the switch downward in order to spray washer fluid onto the window. Release the switch in order to stop the flow of washer fluid. The switch will return to the middle position. Engine Speed Control (12)
Engine Speed - Turn the engine speed dial in order to control the engine speed (engine rpm). Select the desired position from the ten available positions. The selected position of the engine speed dial is indicated on the electronic monitor panel.
Decrease - Turn the engine speed dial counterclockwise in order to decrease the engine speed (engine rpm).
Increase - Turn the engine speed dial clockwise in order to increase the engine speed (engine rpm). Air Conditioning and Heating Control (13)
The heater/air conditioner provides comfort for the operator that is working under various temperature conditions. For more information on the air conditioning and heating controls, refer to Operation and Maintenance Manual, "Air Conditioning and Heating Control".Overload Warning Device (14) (If Equipped)
The switch for the overload warning device is located on the right console.
Overload Warning Device - In lifting applications, the overload warning device activates a buzzer when there is an unstable load condition. When this occurs, the bucket load should be reduced or the stick should be moved inward. ON - Push the right side of the switch in order to deactivate the overload warning device.OFF - Push the left side of the switch in order to activate the overload warning device.Seat Heater (15) (If Equipped)
Preexisting skin conditions can be aggravated by continued use of the seat heater. If skin condition worsens, discontinue use of the seat heater.
Seat Heater - In cold weather, the seat heater can be activated in order to improve operator comfort.
ON - Push down on the top of the seat heater switch in order to activate the seat heater.
OFF - Push down on the bottom of the seat heater switch in order to deactivate the seat heater.
Do not leave any heavy item or object with a sharp point on the seat.Do not cover the seat or seat back with a blanket, seat cushion or any other similar covering. The seat heater can be over heated. Be sure to remove any spills on the seat and thoroughly dry the spill.
Note: The thermostat in the seat heater deactivates when the temperature in the cab is above 10°C (50°F). The seat heater will not operate when the thermostat is deactivated.Travel Speed Control (16)
Use the switch in order to change the travel speed.
Low - Move the switch to this position in