PLATE-CLUTCH 3827515 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
ZZ     6V-9507     Plug     1    
6V-9828 Cap As     1    
9U-7088 Tapered Cap/Plug     1    Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.
Drain the engine coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".
Illustration 1 g01124599
Disconnect hose assembly (1). Disconnect hoses (2) and (5). Remove bolts (4) from water temperature regulator housing (3) .
Illustration 2 g01124602
Rotate water temperature regulator housing (3) toward the front of the machine and disconnect harness assembly (6). Remove water temperature regulator housing (3) .
Illustration 3 g01124601
Remove bolts (7) and remove the outer cover and the gasket from water temperature regulator housing (3) .
Illustration 4 g01124606
Remove water temperature regulators (8) and lip seals (9) .Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     221-8647     Seal Installer Gp     1    
Illustration 5 g01124606
Install lip seals (9) and water temperature regulators (8). Use Tooling (A) in order to install lip seals (9) .
Illustration 6 g01124601
Install the outer cover and a new gasket onto water temperature regulator housing (3) and install bolts (7). Tighten bolts (7) to a torque of 50 9 N m (37 7 lb ft).
Illustration 7 g01124602
Illustration 8 g01124599
Rotate water temperature regulator housing (3) toward the front of the machine and connect harness assembly (6). Install water temperature regulator housing (3). Install bolts (4) that hold water temperature regulator housing (3).
Connect hose assembly (1). Connect hoses (2) and (5).
Fill the cooling system. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".