PLATE-PRESSURE 3847249 - Caterpillar

Illustration 5 g00790815
Install pin (8) to the rod end of the lift cylinder. Install snap ring (7) .
Repeat step 6 for the opposite side.
Illustration 6 g00593552
Connect lines (5) and (6) for both sides of the lift arm assembly.
Illustration 7 g00589421
Install bracket (4) with washers and two bolts (3) .
Illustration 8 g00594375
Connect harness (2) and install a new strap (1) .
Close the engine access door.Installation Procedure for the 252 and the 262
Attach a suitable lifting device to the rear link assembly. Install the rear link assembly into position. The rear link assembly weighs 75 kg (165 lb).
Illustration 9 g00791015
Install pin (16). Install the washer and bolt (15) .
Repeat step 2 for the opposite side.Note: Allow the rear link assembly rest against the frame.
Illustration 10 g00790990
Install hose clamps (14). Install washers and bolts (13) .
Repeat step 4 for the opposite side.
Attach a suitable lifting device to the lift arm assembly. Install the lift arm assembly into position. The lift arm assembly weighs 442 kg (975 lb).
Illustration 11 g00790958
Raise the rear link arm in order to align the pin holes.Note: Install the shims.
Install pin (12). Install the washer and bolt (11) .
Illustration 12 g00790932
Install washer (10) and hex head bolt (9) .
Repeat steps 7 through 9 for the opposite side.
Illustration 13 g00790919
Raise the rear link assembly in order to align the pin holes.Note: Install the shims.
Install pin (8). Install snap ring (7) .
Repeat step 12 for the opposite side.
Lower the lift arm assembly.
Tilt the cab. Refer to Disassembly and Assembly, "Cab - Tilt".
Illustration 14 g00790907
Install hose clamps (6). Install washers and bolts (5) .
Repeat step 16 for the opposite side.
Illustration 15 g00790867
Connect line (4) and line (3) .
Repeat step 18 for the opposite side.
Illustration 16 g00790859
Raise the lift cylinder in order to align the pin holes.
Install pin (2). Install snap ring (1) .
Repeat steps 20 and 21 for the opposite side., End By:
Install the tilt cylinder. Refer to Disassembly and Assembly, "Tilt Cylinder - Install".
Install the quick coupler. Refer to Disassembly and Assembly, "Quick Coupler - Remove and Install".
Lower the cab. Refer to Disassembly and Assembly, "Cab - Tilt".
Check the hydraulic fluid level. Refer to Operation and Maintenance ManualSEBU7468, "Hydraulic System Oil Level - Check".