PLATE AS 3884537 - Caterpillar

Illustration 17.21. Use Tooling (C) in order to remove the retaining ring from output shaft (29).
Illustration 18.22. Remove seal ring (23) from carrier assembly (28).23. If necessary, remove the locating dowel at the base of the shaft on carrier assembly (28).
Illustration 19. To prevent possible damage, do not remove splined adapter (41) from stator (18) unless it is necessary.24. Remove retaining ring (40) from both sides of stator (18).
Illustration 20.25. Remove bolts (25) and gear (26) from impeller (24).
Illustration 21.26. Remove bearing (27) from housing (24).
Illustration 22.27. Remove retaining ring (30) and cap (31) from housing (32).
Illustration 23.28. Use Tooling (C) in order to remove retaining ring (33) from the turbine.
Illustration 24.29. Remove turbine (34) from housing (32).
Illustration 25.30. Remove bolts (36) and hub (35) from turbine (34).
Illustration 26.31. Remove bearing (37) from housing (32).Assemble Torque Converter
Illustration 1.1. Install locating dowel (37) in turbine hub assembly (35).2. Install turbine hub assembly (34) to converter turbine (34). Install sixteen bolts (36) and the washers. The torque for bolts (36) is 60 7 N m (44 5 lb ft).
Illustration 2.3. Raise Converter turbine (34) on a bench, and install the rotating housing (32) over converter turbine (34). Be careful not to pinch your fingers when you lower rotating housing (32) over converter turbine (34).
Illustration 3. The notch on bearing (38) must be aligned with locating dowel (37) on turbine hub assembly (35).4. Install bearing (38).
Illustration 4.5. Install the bearing spacer.6. Use Tooling (C) in order to install retaining ring (33) on the turbine hub assembly. Retaining ring (33) must be securely seated in the grove.
Illustration 5.7. Install the O-ring seal, end cover (31), and retaining ring (30) to housing (32).
Illustration 6.8. Lower the temperature of bearing (27). Install the bearing in impeller (24). The notch in bearing (29) must face upward, as shown.
Illustration 7.9. Install drive gear (26) and eight bolts (25) to impeller (24). Tighten the bolts to a torque of 105 15 N m (77 11 lb ft).
Illustration 8.
Illustration 9.10. Install seal ring (40) on carrier assembly (23). Put clean oil on the seal ring. The notch on bearing (27) must be aligned with the locating dowel on carrier assembly (23).11. Install torque converter impeller (24) on carrier assembly (23).
Illustration 10.12. Install spacer (22). Use Tooling (C) to install retaining ring (21).
Illustration 11.13. Install one retaining ring (19) and heat stator (18) to a temperature of 121°C (250°F). Maintain the temperature for one hour. Install splined hub (20) in stator (18) before the stator is allowed to cool. Install second retaining ring (19) to the other side of stator (18) in order to hold the unit together.
Illustration 12.14. Install stator (18) on the impeller.15. Install retaining ring (17) on the end of the carrier assembly (23) in order to hold the stator.
Illustration 13.16. Install seal ring (29) on the output shaft (15). Use steps 17 through 19 for the installation of a split bearing assembly (newer models).
Illustration 14.17. Install piston ring (39) on output