PLATE-WRAPPER 3885432 - Caterpillar

Customer Passwords
First Password____________________Second Password____________________Injector Trim Codes
Injector 1____________________Injector 2____________________Injector 3____________________Injector 4____________________Injector 5____________________Injector 6____________________Engine Parameters
Note: If an Electronic Modular Control Panel (EMCP) is connected to the engine, the following engine parameters can affect generator set operation. For more information on engine parameters, refer to the Electronic Troubleshooting Manual for this engine. For more information on the EMCP electronic control, refer to the Service Manual.FRC Offset Value____________________Rated Fuel Position (mm)____________________Fuel Correction Factor____________________Breakpoint Setting____________________Governor Gain____________________Acceleration Delay Time____________________Acceleration Ramp Rate____________________"User-Defined Switch Installation Status"____________________"User-Defined Switch Active State Configuration"____________________High Engine RPM Limit____________________Low Idle Engine RPM____________________Engine Cooldown Duration____________________Cooldown Speed____________________Maximum Number of Crank Cycles____________________Crank Cycle Duration____________________Crank Terminate Speed____________________"Coolant Level Sensor Installation Status"____________________"Exhaust Temperature Sensor Installation Status"____________________"Fuel Pressure Sensor Installation Status"____________________"Oil Temperature Sensor Installation Status"____________________Air Shutoff____________________Ether Control____________________Engine Monitoring System
Low Battery Voltage
Warning Trip Point____________________Warning Delay Time____________________Low Coolant Temperature
Warning Trip Point____________________Warning Delay Time____________________Engine Overspeed
Warning Trip Point____________________Warning Delay Time____________________Shutdown Trip Point____________________Shutdown Delay Time____________________Inlet Air Temperature
Warning Delay Time____________________High Exhaust Temperature
Warning Trip Point____________________Warning Delay Time____________________High Engine Oil Temperature
Warning Trip Point____________________Warning Delay Time____________________Shutdown Trip Point____________________Shutdown Delay Time____________________Low Coolant Level
Warning Delay Time____________________Shutdown Delay Time____________________User-Defined Switch
Warning Delay Time____________________Shutdown Delay Time____________________The customer specified parameters can be changed as often as needed. Password protection is provided so that the customer can change the parameters. The customer can authorize someone else to change the parameters. Ensure that a record of the parameters is kept in the Operation and Maintenance Manual. For detailed instructions on programming the engine for optimum performance and for optimum fuel economy, consult your Caterpillar dealer.