PLATE AS 3900844 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-7575 Link Bracket 2
B - Loctite 5188 -
Illustration 1 g02437857
Attach Tooling (A) and a suitable lifting device onto flywheel housing (24). The weight of flywheel housing (24) is approximately 726 kg (1600 lb). Apply Tooling (B) to the mating surface of flywheel housing (24). Position flywheel housing (24). Install bolts (26).
Illustration 2 g01220583
Install bolts (25) that connect the oil pan to flywheel housing (24).
Illustration 3 g01220569
Install crankshaft position sensor (22). Install bolt (21). Connect harness assembly (23).
Illustration 4 g02437259
Install the gasket seal and cover (19). Install three bolts (17) and bolt (20). Connect harness assembly (18).
Illustration 5 g02436139
Rotate the engine so that the number one piston is at top dead center on the compression stroke. Refer to Testing and Adjusting, "Finding Top Center Position for No. 1 Piston".
Install cam gear (16). Install bolts (15).
Illustration 6 g02436136
Install cover (14). Install bolts (13). Install cover (12). Install bolts (11).
Illustration 7 g02436118
Install lift eye (5). Install elbows (3) and (4). Position turbocharger mounts (1). Install bolts (2). Install bracket (8) and bolts (6).
Install tube assemblies (7) and (9). Connect harness assemblies (10).
Install sections of the heat shield removed to gain access to components.End By:
Install the air shutoffs.
Install the starters.
Install the aftercooler.
Install the turbocharger.
Install the exhaust elbow.
Install the crankshaft rear seal.
Install the flywheel.