PLATE & FILM GP 3904505 - Caterpillar

Lower - Push lever (14) forward to lower the blade. The lever will return to the HOLD position when you release the lever. The blade will remain in the selected position.Hold - Lever (14) will return to the HOLD position when the lever is released from the RAISED or LOWERED position.
Raise - Pull lever (14) backward to raise the blade. The lever will return to the HOLD position when you release the lever. The blade will remain in the selected position.Adjustable Gauge Undercarriage Control (14)
Before operating the adjustable undercarriage control, refer to Operation and Maintenance Manual, "Adjustable Gauge Undercarriage Frame".Power Outlet (15)
A 12V power receptacle is on the right side console. This power receptacle can be used for powering automotive electrical equipment or accessories. Raise the cap before use.Note: This receptacle can also be used for the service light.Engine Start Switch (16)
For safety reasons, put the hydraulic lockout lever in the RAISED position when you are starting the engine.
OFF - Insert the engine start switch key only from the OFF position and remove the engine start switch key only from the OFF position. In the OFF position, there is no power to most electrical circuits.Turn the engine start switch key to the OFF position to stop the engine.
ON - Turn the engine start switch key to the ON position to energize all the electrical circuits. The fuel pump is on and the indicator lights illuminate.
RUN - The engine start switch returns to this position once the engine has been started.Note: Leave the engine start switch key in the RUN position for 4 seconds to heat the glow plugs. Attempt to start the engine.
START - Turn the engine start switch key clockwise to the START position to crank the engine. Release the engine start switch key after the engine starts and the engine start switch key returns to the RUN position.Note: If the engine fails to start, the engine start switch key must be returned to the OFF position to attempt to start the engine again.Boom Swing Control (17)
Unexpected operation of the boom swing control can cause injury or death.A vertically folded boom swing control pedal does not mean that the boom swing function is locked out.To prevent unexpected activation of the boom swing control while traveling or whenever the boom swing control is not being used, make sure that the boom swing control pedal is folded vertically.
The boom swing pedal is used to swing the boom to the right or to the left. The boom swing pedal is on the floor on the right side.The boom swing control pedal is hinged and spring loaded. Operate the boom swing control pedal by folding the pedal down to the horizontal position.Note: Remove your foot from the pedal when not in use and the pedal will automatically return to the vertical position.
Illustration 11 g02463797
Swing Left (17a) - Push down on the front half of the boom swing pedal to swing the boom to the left.
Swing Right (17b) - Push down on the