PLATE-WEAR 3914976 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
ZZ     6V-9507     Face Seal Plug (9/16 - 18 THD)     2    
6V-9508 Cap Assembly (9/16 - 18 THD)     2    
6V-9509 Face Seal Plug (13/16 - 16 THD)     6    
6V-9830 Cap Assembly (13/16 - 16 THD)     6    Start By:
Tilt the cab. Refer to Disassembly and Assembly, "Cab - Tilt".
Tilt the operator platform. Refer to Disassembly and Assembly, "Operator Platform - Tilt".Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide"for tools and supplies to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g00828948
Remove bolt (2) and pin (3) from steering cylinder (1) .
Illustration 2 g00828950
Disconnect hose assemblies (4) from steering cylinder (1) .
Illustration 3 g00828952
Disconnect hose assembly (5) from steering cylinder (1) .
Illustration 4 g00828953
Remove bolt (7) and pin (6) from steering cylinder (1). Remove the steering cylinder from the machine.Installation Procedure
Illustration 5 g00828953
Install steering cylinder (1), pin (6), and bolt (7) .
Illustration 6 g00828952
Connect hose assembly (5) on steering cylinder (1) .
Illustration 7 g00828950
Connect hose assemblies (4) on steering cylinder (1) .
Illustration 8 g00828948
Install pin (3) and bolt (2) in steering cylinder (1) .