PLATE AS 3970155 - Caterpillar

j) Install the O-ring seal on carrier. 69. Install the ring gear (84) for No. 3 clutch.70. Put seal ring (83) in center of its groove.71. Install the No. 2 and No. 3 carrier (82) in the clutch housing.
Use care when lowering No. 2 and No. 3 carrier into place to prevent damaging seal ring (83) in carrier.
72. Install the ring (85) that holds No. 2 and No. 3 carrier in position. 73. Install two 3/8"-16NC forged eyebolts in No. 3 clutch housing. Fasten a hoist and install the No. 2 and No. 3 carrier, No. 4 carrier, and No. 3 clutch housing as a unit.74. Install the three disc assemblies and two plates for the No. 3 clutch starting with a disc assembly. 75. Install the No. 3, No. 4, and No. 5 clutch pins (86).76. Install the No. 3 clutch springs (87). 77. Install seal ring in piston (88) and in No. 2 clutch housing (89). Put oil on seal rings.78. Put the seal rings in the center of their grooves. Put piston (88) on housing (89), and softly push the piston into No. 2 clutch housing.
When installing piston into housing, use care to prevent damaging the seal rings. Never use a hammer to install piston. Broken seal rings may be the result.
79. Install No. 2 clutch housing on planetary group. 80. Install retaining ring (92) on carrier.81. Install the ring gear (91) for No. 2 clutch.82. Install ring gear (90) for No. 1 and No. 2 carrier. Install the two pins that hold the retaining ring (92) in position.83. Install the four disc assemblies and three plates of the No. 2 clutch starting with a disc assembly. 84. Install the pins (94) for the No. 1 and No. 2 clutch.85. Install springs (93) for No. 2 clutch. 86. Install seal ring in piston (95) and in No. 1 clutch housing (96). Put oil on seal rings.87. Put the seal rings in the center of their grooves. Put piston (95) on housing (96), and softly push the piston into No. 1 clutch housing.
When installing piston into housing, use care to prevent damaging the seal rings. Never use a hammer to install piston. Broken seal rings may be the result.
88. Install the ring gear (98) for No. 1 clutch.89. Install the four disc assemblies and three plates for the No. 1 clutch starting with a disc assembly.90. Install the springs (97) for No. 1 clutch. 91. Install bearing (99) in cage (100).92. Install seal ring (101) on cage (100) and seal ring (102) on plate (103). Put oil on the seal rings. Install cage (100) in plate (103).
Do not twist, bend, or open the seal rings more than necessary during installation. When installed, seal ring must be free to move in grooves.
93. Install the ring that holds bearing and cage (100) in position.94. Assemble the No. 1 carrier as follows: a) Put a bearing (104) inside each of the three No. 1 planet gears (105).b) Put the