3C8539 PLATE AS Caterpillar parts
Rating:
Alternative (cross code) number:
CA3C8539
3C-8539
3C8539
CA3C8539
3C-8539
3C8539
Weight: 0.25 pounds 0 kg.
For full view, you need register
Information:
Disassembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 8S-2264 Puller Group 1
4B-3903 Bolt
5/16 - 18 NC by 4 inch 2
1P-0456 Plate 1
4B-4277 Washer 2
B 1P-0510 Driver Group 1 Start By:
Remove the water pump. Refer to Disassembly and Assembly, "Water Pump - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: The water pump seal can be replaced without removing the water pump from the engine.Note: An intermittent leakage of a small amount of coolant from the hole in the water pump housing is not an indication of a water pump seal failure. This is required to provide lubrication for the seal. Do not replace the water pump seal unless a large amount of leakage or a constant flow of coolant is draining from the water pump housing.
Illustration 1 g01195730
Remove adapter (15).
Remove bolt (9) and washer (8).
Use Tooling (A) to remove impeller (5) from shaft (10).
Remove bolt (7), washer (6), and gear (4) from shaft (10).
Remove bolts (11) and retainer (13).
Remove O-ring seal (14) from housing (3).
Use a suitable press to remove shaft (10) and bearing assembly (1) from housing (3).
Use a suitable press to remove bearing assembly (1) from shaft (10).
Remove seal assembly (12) from housing (3).
Use Tooling (B) to remove lip seal (2) from the housing.
Table 1
Required Tools
Tool Part Number Part Description Qty
A 8S-2264 Puller Group 1
4B-3903 Bolt
5/16 - 18 NC by 4 inch 2
1P-0456 Plate 1
4B-4277 Washer 2
B 1P-0510 Driver Group 1 Start By:
Remove the water pump. Refer to Disassembly and Assembly, "Water Pump - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: The water pump seal can be replaced without removing the water pump from the engine.Note: An intermittent leakage of a small amount of coolant from the hole in the water pump housing is not an indication of a water pump seal failure. This is required to provide lubrication for the seal. Do not replace the water pump seal unless a large amount of leakage or a constant flow of coolant is draining from the water pump housing.
Illustration 1 g01195730
Remove adapter (15).
Remove bolt (9) and washer (8).
Use Tooling (A) to remove impeller (5) from shaft (10).
Remove bolt (7), washer (6), and gear (4) from shaft (10).
Remove bolts (11) and retainer (13).
Remove O-ring seal (14) from housing (3).
Use a suitable press to remove shaft (10) and bearing assembly (1) from housing (3).
Use a suitable press to remove bearing assembly (1) from shaft (10).
Remove seal assembly (12) from housing (3).
Use Tooling (B) to remove lip seal (2) from the housing.