PLATE 3P2346 - Caterpillar

Installation Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over any disconnected fuel system components.
Note: Put identification marks on all hose assemblies, on all tube assemblies, and on all wires for installation purposes. Plug all hose assemblies and all tube assemblies. This will help prevent fluid loss, and keep contaminants from entering the system.
Illustration 1 g06318401
Tube has been made transparent for clarity.
Position fuel manifold (3) and install bolts (9).
Illustration 2 g06318393
Tube has been made transparent for clarity.
Install the O-ring seal on fuel temperature (8).
Install the fuel temperature sensor (8) on the fuel manifold and tighten to a torque of 20 3 N m (15 2 lb ft).
Connect harness assembly (7) to fuel temperature sensor (8).
Illustration 3 g06318201
Tube has been made transparent for clarity.
Install check valve (6).
Illustration 4 g06318194
Tube has been made transparent for clarity.
Connect hose assemblies (1), (2), (4), and (5) to fuel manifold (3).
Remove the air from the fuel system. Refer to Testing and Adjusting, "Fuel System - Prime".