PLATE (IDENTIFICATION) 3P8336 - Caterpillar

Table 1
Customer Specified Parameters    
ECM Parameter    Possible Values    Default Value    
Engine Rating Parameter    
"Rating Number"     1 to 4     1    
Low/High Idle Parameters    
"Low Idle Speed"     700 to 1200 rpm     750 rpm    
"High Idle Speed"     1900 to 2900 rpm     2650 rpm    
ECM Identification Parameter    
"Equipment ID"     17 Digits
Available characters are dependent on the service tool that is used     Not Programmed    
PTO and Throttle Lock Parameters    
"Throttle Lock Feature Installation Status"     Installed
Not Installed     Not Installed    
"PTO Engine Speed Setting"     0 to 3000 rpm     0 rpm    
"Throttle Lock Increment Speed Ramp Rate"     0 to 600 rpm/sec     400 rpm/sec    
"Throttle Lock Engine Set Speed Increment"     0 to 200 rpm     10 rpm    
Miscellaneous    
"Monitoring Mode Shutdowns"     Disabled
Enabled     Disabled    
"Monitoring Mode Derates"     Disabled
Enabled     Enabled    
"Limp Home Desired Engine Speed"     700 to 1800 rpm     1200 rpm    
J1939 Continuous Fault Handling    
"Remote Torque Speed Control Enable Status"     Disabled
Enabled     Disabled    
Configurable Inputs    
"Coolant Level Sensor"     Not Installed
Installed     Not Installed    
"Air Filter Restriction Switch Installation Status"     Not Installed
Installed     Not Installed    
"Fuel/Water Separator Switch Installation Status"     Not Installed
Installed     Not Installed    
"User Defined Switch Installation Status"     Not Installed
Installed     Not Installed