PLATE 3T5830 - Caterpillar

"Maximum PTO Enable Speed"
This parameter specifies the maximum engine speed for the engagement of the PTO mode. The PTO mode will engage when the engine rpm is equal to the programmed limit or less than the programmed limit. This parameter is only available when the "PTO Configuration" is programmed to "Cab Switches", "Remote Switches", or "Remote Throttle".
Table 7
Minimum     Maximum     Default    
700 rpm     TEL rpm     TEL rpm    "PTO Cab Controls RPM Limit"
This determines the engine rpm limit of the cab mounted Accelerator Pedal Position Sensor when "PTO Configuration" is programmed to "Cab Switches" and the "PTO On/Off" circuit is on. This parameter is intended to prevent engine overspeed when dedicated PTO is used.
If the parameter is programmed to Low Idle, the Cab Controls are ignored.
If the parameter is programmed to "Top Engine Limit" (TEL), the engine will operate to the programmed "Top Engine Limit".
If the parameter is programmed to "PTO TEL", the engine will operate to the programmed "PTO Top Engine Limit".Note: "PTO Configuration" must be programmed to Cab Switches for this parameter to take effect. If "PTO Configuration" is programmed to Remote Switches or Remote Throttle, the ECM will always ignore the Cab Throttle when the "PTO On/Off" circuit is on.
Table 8
Alternative     Default    
Low Idle
TEL
PTO TEL     TEL    "PTO Kickout Vehicle Speed Limit" (VSL)
This is the maximum vehicle speed for setting or maintaining a set engine rpm in PTO mode. PTO mode is entered if the "PTO On/Off" Switch is on. (This uses Input 1.) If the vehicle speed signal exceeds this value, the engine will not maintain the set engine rpm.
Table 9
Minimum     Maximum     Default    
2 km/h (1 mph)    
204 km/h (127 mph)    
2 km/h (1 mph)    "Torque Limit"
Illustration 1 g00628600
Operation of Torque limit (1) Programmed torque limitThe parameter for the "Torque Limit" defines the maximum torque output of the engine during Dedicated PTO operation. This parameter provides temporary protection of equipment. The Torque limit of the engine is active when the circuit for the Torque Limit Switch is on. The maximum value is the Rated Torque of the engine. The "Torque Limit" is programmable to N m (lb ft) of torque. Programming a value higher than the Rated Torque is limited by the ECM to Rated Torque. The torque limit is indicated by the dashed line in Illustration 1.
Table 10
Minimum     Maximum     Default    
270 N m (200 lb ft)    
3400 N m (2500 lb ft)    
3400 N m (2500 lb ft)    "PTO Shutdown Time"
The "PTO Shutdown Time" sets the amount of idle time before the PTO shuts down. The time begins when the "PTO On/Off" circuit is on and there is no vehicle speed. The PTO Shutdown Timer will not begin counting if the engine is in Cold Mode. This parameter requires the "PTO Configuration" to be programmed to Cab Switches, Remote Switches or Remote Throttle for the timer to function.Note: This feature does