PLATE AS 4366808 - Caterpillar

CaterpillarMonitorand the Caterpillar Electronic Technician (ET) may be used in order to perform the following hydraulic system calibrations:Note: The Caterpillar Electronic Technician (ET) is the preferred method of calibration.
Position sensors for the implement control lever
Tilt linkage position sensor
Lift linkage position sensor
Proportional solenoids for the pilot control actuators
Tilt cylinder position sensor
Lift cylinder position sensorCalibrations must be performed when any of the following conditions occur:
Replacement of the implement electronic control module (ECM)
Removal or replacement of the tilt cylinder position sensor
Removal or replacement of the lift cylinder position sensor
Removal or replacement of the tilt cylinder
Removal or repair of the proportional solenoids for the pilot control actuatorsCalibrations must be performed in the following order:
Position sensors for the implement control lever
Lift cylinder position sensor
Tilt cylinder position sensor
Proportional solenoids for the pilot control actuators Clear any logged fault codes after you have completed the calibrations.ReferenceFor additional information on calibrations of the implement system, refer to Troubleshooting and Testing and Adjusting for the component that needs to be calibrated.