AVSPARE.COM
parts catalog

PLATE & FILM GP 4415831 - Caterpillar



4415831 PLATE & FILM GP Caterpillar parts PLATE
Rating:
71
Alternative (cross code) number:
CA4415831
441-5831
4415831
Caterpillar 4415831 PLATE & FILM GP

Buy PLATE & FILM GP 4415831 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme:
  
  For full view, you need register

Information:

ECM (Controller Logic)
Communication
Machine ECM (30) communicates with the operator controls on the instrument panel and the screed operator stations through CAN "C" communication lines. The CAN "C" requires a positive line and a negative line. The positive line is connected to terminal "J1-20" of the ECM. The negative line is connected to terminal "J1-10" of the ECM. These communication lines contain termination resistor (8) and (12).Machine ECM (30) communicates with display (10) through CAN "A" communication lines. These communication lines contain termination resistor (7) and (13).Conveyor and Auger Control
For those machines configured with two material height sensors, the operator can vary the relative speed of the conveyors to the augers. The right conveyor control dial and the left conveyor control dial allow the operator to vary this relative speed. When the control setting is at 0 percent, the dials provide the maximum speed differential between the conveyors and the augers. At zero percent, the conveyor operates at the minimum speed. When the control setting is at 100 percent, the dials provide the minimum speed differential between the conveyors and the augers. At 100 percent, the conveyor operates at the maximum speed.For those machines configured with four material height sensors, the operator can vary the speed of the conveyors based on the height of material at the back of the conveyors. The right conveyor control dial and the left conveyor control dial allow the operator to vary the speed of the conveyors. The height of the material at the back of the conveyors is measured by the conveyor material height sensors. In this configuration, the conveyors and the augers operate independently.The machine ECM automatically detects if the machine is equipped with paddle sensors or sonic sensors. The ECM monitors the status of the following terminals:
Terminal "J1-34" - right conveyor
Terminal "J1-33" - left conveyor
Terminal "J2-45" - right auger
Terminal "J2-44" - left auger.When paddle sensors are installed, these terminals are floating. When sonic sensors are installed, these terminals are grounded by the sensor.The machine ECM compares the input signals from the conveyor material height sensors to the input signals from the conveyor control dials. Then, the machine ECM

Caterpillar SIS machinery equipment:

Caterpillar SIS

Caterpillar parts catalog:

Caterpillar parts catalog
CS54B, CP54B Vibratory Compactor 48200001-UP (MACHINE) POWERED BY C4.4 Engine
CS54B, CP54B Vibratory Soil Compactor CS500001-UP (MACHINE) POWERED BY C4.4 Engine


Parts plate Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.