AVSPARE.COM
parts catalog

PLATE AS-HINGE 4416112 - Caterpillar



4416112 PLATE AS-HINGE Caterpillar parts PLATE
Rating:
66
Alternative (cross code) number:
CA4416112
441-6112
4416112
Caterpillar 4416112 PLATE AS-HINGE

Buy PLATE AS-HINGE 4416112 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Two-Piece Articulated Piston
Illustration 1 g00293184
Illustration 2 g01093113 (1) Crown assembly (2) Connecting rod Note: Install the rod and piston group in the engine with the part number of the forging for the rod assembly to the rear of the engine. The rear of the engine is the flywheel end of the engine. Lubricate the rod and piston group with clean engine oil before you insert the rod and piston group into the block.Top Ring and Intermediate Ring
(3) The top ring has the mark "UP-1". Install the piston ring with the side marked "UP-1" toward the top of the piston. The colored stripe faces to the right of the ring end gap.Piston ring end gap ... 0.40 0.10 mm ( 0.016 0.004 inch)Thickness of new top piston ring ... 3.453 mm (0.1359 inch) (4) The intermediate ring has the mark "UP-2". Install the piston ring with the side marked "UP-2" toward the top of the piston. The colored stripe faces to the right of the piston ring end gap.Piston ring end gap ... 1.50 0.10 mm (0.060 0.004 inch)Width of groove in new piston for intermediate piston ring ... 3.06 0.01 mm (0.121 0.001 inch)Thickness of new intermediate piston ring ... 2.98 mm (0.117 inch)Oil Control Ring
(5) The oil control piston ring has a spring that is installed with the ring. The gap in the spring should be a distance of 180 degrees from the ring end gap when the oil control piston ring is assembled. The colored portion can be to the right or to the left of the ring end gap. Piston ring end gap ... 0.45 0.15 mm (0.018 0.006 inch)Width of groove in new piston for oil control piston ring ... 4.03 0.01 mm (0.159 0.001 inch)Thickness of new oil control piston ring ... 3.98 0.01 mm (0.157 0.001 inch)After the piston rings have been installed, rotate the piston rings so that the end gaps are 120 degrees from each other. (6) Piston skirt Lubricate the entire piston in zone (A) prior to assembly into the cylinder block. Use clean engine oil.Piston Pin
(7) Piston pin Piston pin diameter ... 46.000 0.005 mm (1.8110 0.0002 inch)Length of piston pin ... 91.50 0.15 mm (3.602 0.006 inch)Thoroughly lubricate the piston pin with clean engine oil prior to assembly.


Parts plate Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.