PLATE 4644090 - Caterpillar

Table 1
Required Part List
Qty New Part Number Part Name
1 532-8304 Lumbar Support Kit If the seat lumbar adjustment control bezel becomes loose, perform the following procedure.Rework Procedure
This rework procedure will add a cable strap that forces the bezel tabs to engage with the seat frame.
Illustration 1 g06213660
(A) Cable strap
Bend the end of cable strap (A) to assist going in and out of the seat back frame.
Illustration 2 g06213664
(A) Cable strap
(B) Seat back frame
Install the cable strap (A) through the top hole on seat back frame (B).
Illustration 3 g06213680
(A) Cable strap
While feeding the cable strap (A) through the top hole, apply pressure to the foam to allow the strap to come back through the bottom hole.
Illustration 4 g06213686
(A) Cable strap
Feed the cable strap (A) until the strap can be connected together.
Illustration 5 g06213689
(A) Cable strap
Connect the cable strap (A) together.
Illustration 6 g06213691
(A) Cable strap
Cut the excess material on the cable strap (A).
Illustration 7 g06213694
(C) Control bezel
Install the control bezel (C), starting with placing the bottom tab into the mating hole on the seat back frame.
Illustration 8 g06215093
(C) Control bezel
While installing the control bezel (C), push until you hear a click.
Illustration 9 g06215097
(C) Control bezel
To insert the top tab on the control bezel (C), a flat head screw driver is required.
Illustration 10 g06157786
A light-duty hammer is used to insert the top tab.
Illustration 11 g06215100
(C) Control bezel
Once the control bezel (C) is fully seated, the back cover may need to be moved to align the cut out properly.