PLATE AS-SIDE 4648861 - Caterpillar

Table 1
Text View Options for 3D Systems    
Items     Details    
"Alignment"     Displays description of line that is used for horizontal guidance    
"Avoid. Dist."     If a Ripper back from cutting edge measurement is entered then 4 points based on blade tip position and the ripper back from cutting edge measurement are used for avoidance zone proximity detection. The Avoid. Dist is the shortest distance between any one point and the closest avoidance zone.    
"Card Time"     Displays the amount of time left on the data card until the card is full. Used when recording mapping onto the data card.    
"Cross Slope"     Cross slope of the blade orthogonal to the direction of travel. This is not the measured tilt of the blade.    
"Cut Adjust"     When Cut adjustment is Off, the text field indicates "N/A". When Cut adjustment is On and adjustment is applied, the text field shows the larger of the applied cut adjustments for the blade tips.    
"Cut/Fill Left"     Shows either Cut Left or Fill Left, as appropriate, for the left blade tip. If a vertical offset is specified, the Cut or Fill is to the vertically offset position.    
"Cut/Fill Right"     Shows either Cut Right or Fill Right, as appropriate, for the right blade tip. If a vertical offset is specified, the Cut or Fill is to the vertically offset position.    
"Design Elev"     Design elevation at the blade tip with focus.    
"Design Mainfall"     Mainfall of the design parallel to the direction of travel    
"Design Name"     Displays the design name.    
"Design XSlope"     Cross slope of the design orthogonal to the direction of travel    
"Easting"     Easting at the blade tip with focus.    
"Elevation"     Elevation at the blade tip with focus.    
"GPS Acc. Mode"     The selected GPS Accuracy mode is displayed. GPS Accuracy modes are fine, medium and coarse.    
"H. GPS Error"     A measure of the horizontal GPS Accuracy. The text is red if the value exceeds the current GPS error limit. The text is blue if the value is close to the limit. Otherwise the text is black.    
"Heading"     Direction the machine is moving. Shown in degrees clockwise from the north.    
"Layered Lift"     Vertical Offset between the master alignment and the working surface when a layered lift is defined. Value is positive if the layered lift is above the master alignment, negative if the layered lift is below the master alignment and "N/A" when no layered lift is defined.    
"MA Offset"     Offset from the blade tip with focus to the master alignment. Also see the item "Offline" in this table.    
"Mainfall"     Mainfall of the machine in the direction of travel    
"Northing"     Northing at the blade tip with focus.    
"Offline"     Offline distance from the blade tip with focus to the selected alignment. If a horizontal offset is specified, the