PLATE AS 4663102 - Caterpillar

Move propel lever (1) into the maximum position opposite of the direction of travel. The farther the lever is moved, the faster the machine will stop. Release the lever.
Verify that the parking brake is engaged by checking parking brake indicator (2). The parking brake should activate automatically when the machine is stopped. If the parking brake is not active, use propel lever (1) to stop the machine completely.
Illustration 2 g06228685
Ensure that the conveyor system is deactivated. The indicator light next to the button should be off. If the conveyor system is operating, push conveyor drive on/off button (5) to deactivate.
Ensure that the water spray system is deactivated. The indicator light next to the button should be off. If the water spray system is operating, push water spray button (3) to deactivate.
Ensure that the vacuum dust control system, if equipped, is deactivated. The indicator light next to the button should be off. If the vacuum dust control system is operating, push vacuum dust control button (4) to deactivate.
Illustration 3 g06228728
Ensure that the rotor system is deactivated. Indicator light next to the button should be off. If the rotor system is operating, push rotor button (6) to deactivate.
Illustration 4 g06228737
Use conveyor buttons (7) to center the conveyor.
Use propel lever (1) to center the front tracks.
Illustration 5 g06229133
Observe level indicator (8). If the indicator shows "0" go to Step 12. If the indicator does not show "0", go to Step 11.
Illustration 6 g06229150
Use rear leg height switches (9) and (10) to level the rear of the machine. Level indicator (8) will show "0" when the rear of the machine is level. Make sure that the rotor does not contact the ground during this step.
Illustration 7 g06229152
Ensure that the engine is operating in low idle. The high idle indicator light should be off. If this indicator is illuminated, press throttle control button (11) to operate the engine in low idle.
Illustration 8 g06229156
Move engine start switch (12) to the OFF position.
Illustration 9 g06229860
Unhook latch (13). Open compartment door (14) under the instrument panel.
Illustration 10 g06229862
Loosen lock wheel (16), and rotate needle valve (15) clockwise to close the valve.Test Procedure
Move engine start switch (12) to the START position. Release the switch when the engine starts.
Illustration 11 g06230808
Use travel mode button (17) to set the machine to roading mode. The indicator next to the button illuminates when the machine is in the roading mode.
Use throttle control button (11) to operate the engine in high idle.
Illustration 12 g06230809
Monitor hydraulic oil temperature (18) on the operator display. Operate the machine until the oil temperature reaches the test temperature listed in the "Specification" section.
Illustration 13 g06230810
Press interlock button (19), and slowly move propel lever (1) into the FULL FORWARD position. The machine should not move.
Move propel lever (1) into the FULL REVERSE position to place the machine in neutral. Release the propel lever.
Use throttle control button (11) to operate the engine in low idle.
Move engine start switch (12) to the OFF position.
If the machine moved during this test, repair the parking brakes.
Rotate needle valve (15) counterclockwise to open the valve.