PLATE-SERIAL 4800418 - Caterpillar

Illustration 1 g00927661
Section View of Vane Pump for the Implements (1) Small section (2) Large sectionThe vane pump for the implements is a two-section vane pump. The vane pump draws oil from the hydraulic tank.Note: Each section of the two-section vane pump operates similarly. An explanation of the operation of a typical vane pump follows.
Illustration 2 g01000593
Schematic of the Cartridge Assembly for a Typical Vane Pump (3) Rotor (4) Cam ring (5) Outlet (6) Passage (7) Inlet (8) Inlet (9) Outlet (10) Vane (A through G) Vane positions (AA) Pressure oil (BB) Supply oilThe cartridge assembly for a typical vane pump is composed of the following components:
Plate
Adapter
Seal packs
Rotor (3)
Cam ring (4)
Vanes (10) Initially, vanes (10) are forced outward by centrifugal force. The pressure oil in passages (6) keeps the vanes (10) along the contour of cam ring (4). Both ends of the vanes are connected by these passages. The oil in these passages keeps the pressure equal on both ends of the vanes. Also, the oil behind the vanes is allowed to escape as the vanes are pushed inward.As rotor (3) turns clockwise, the vanes in positions (A) and (B) extend outward along the contour of the cam ring. As the chamber area between the vanes increases, the oil pressure drops and a vacuum is created in the chamber. This pressure difference causes oil to flow from the hydraulic oil tank and through inlet (7). The oil fills the space between positions (B) and (D) .Oil between the vanes at positions (B) and (C) will be trapped when the vanes pass the end of inlet (7). As rotor (3) continues to turn, the vanes are pushed inward by the contour of cam ring (4). The chamber area between the vanes now decreases. The pressure of the oil increases.Pressurized oil between the vanes at positions (D) and (E) is pushed into outlet (5). The oil continues to be pushed through the outlet between positions (E) and (F). When the vane at position (E) passes the end of outlet (5), the cycle is complete.Note: The oil that enters inlet (8) flows through the cartridge assembly and through outlet (9) similarly to the oil that enters inlet (7).