PLATE-LUG 4822742 - Caterpillar

Machine ECM Event Code List
The following table lists the event codes that apply to the machine control system. The possible cause/recommended response is listed. Use the Cat ET service tool in order to determine the event codes that are active or logged.
Table 1
Machine ECM System Event Identifier (EID) Codes    
Code and Description     Possible Cause / Recommended Response    
E83 (2S) Transmission Overspeed     A Change in operation of the machine or performance of a maintenance procedure is required.
Activated when drive motor speed exceeds 5500 rpm. This event is logged.    
E273 (2) Machine operation attempted using an invalid key (MSS)     Use of invalid key (applies only to machines equipped with MSS)    
E283 (1) Low Hydraulic Charge Pressure     A machine system requires attention.
The hydraulic oil pressure switch indicates low pressure. This event should always be active when the machine is keyed-on and the engine is not running.    
E283 (3) Low Hydraulic Charge Pressure     Immediate safe shutdown is required.
The hydraulic oil pressure switch indicates low pressure while the engine is running. A problem exists with the machine's hydraulic system, or the switch is stuck in the low pressure position.    
E353 (2) Machine Configuration Changed     See Troubleshooting, "E353 Machine Configuration Changed"    
E360 (1) Low Engine Oil Pressure     A machine system requires attention.
The engine oil pressure switch indicates low pressure. This event should always be active when the machine is keyed-on and the engine is not running.    
E360 (3) Low Engine Oil Pressure     Immediate safe shutdown is required.    
E361 (1) High Engine Coolant Temperature     A machine system requires attention.
The engine coolant temperature sensor indicates to the machine ECM that the engine coolant temperature is consistently high enough to issue a Level 1 warning. Inspect the engine cooling system for efficiency of operation.    
E361 (2) High Engine Coolant Temperature     A Change in operation of the machine or performance of a maintenance procedure is required.
The engine coolant temperature sensor indicates to the machine ECM that the engine coolant temperature is consistently high enough to issue a Level 2 warning. Inspect engine cooling system for efficiency of operation    
E361 (3) High Engine Coolant Temperature     Immediate safe shutdown is required.
The engine coolant temperature sensor indicates to the machine ECM that the engine coolant temperature is consistently high enough to issue a Level 3 warning. Inspect engine cooling system for efficiency of operation.    
E362 (2) Engine Overspeed     A Change in operation of the machine or performance of a maintenance procedure is required.
Activated when engine speed exceeds 3500 rpm.
Repair the cause of the active diagnostic code.    
E490 (2S) Park Brake Applied while Shift Lever not in Neutral     See Troubleshooting, "E490 Park Brake Applied while Shift Lever not in Neutral"    
E575 (3) Unexpected Drive Motor Forward Speed Detected     See Troubleshooting, "E575 Unexpected Drive Motor Forward Speed Detected, E576 Unexpected Drive Motor Rearward Speed Detected"    
E576 (3) Unexpected Drive Motor Rearward Speed Detected