PLATE ASSEM. 4L3752 - Caterpillar

Illustration 1 g00664119
Front View of Pump Drive (A) Tapped holes
Drill holes (A) by using a drill that has a diameter of 14.25 mm (0.561 inch). Drill to a maximum depth of 36.0 mm (1.42 inch).Note: Make sure that you do not drill the holes to more than a depth of 36.0 mm (1.42 inch). You may drill through the housing if you drill to more than a depth of 36.0 mm (1.42 inch).Note: You must use a tap that has fewer lead threads. The amount of lead threads should be less than the amount of lead threads on a standard tap. This is necessary to get the correct minimum tapped depth with the holes drilled to the maximum drilled depth.
Tap holes (A) by using a M16 X 2 - 6H THD bottom tap. Tap holes (A) to a depth of 29.0 mm (1.14 inch).Note: Make sure that you tap holes (A) to a depth of 29.0 mm (1.14 inch). This depth is critical in order to get the correct thread engagement.