PLATE AS-BACKING 4P6523 - Caterpillar

The following illustrations provide information about the default settings for the utility malfunction relay.The areas of the dialogs that are within the red dotted outline are the default settings that must be used.Note: Any other protection tab that is not listed is disabled.Note: If custom settings are used in the UMR, first create and then save a settings file of the default settings. Store the settings so that the settings can easily be restored at the conclusion of the custom settings requirement.The XQ power module may be equipped a UMR. The BE1- IPS100 was used with early serial numbers. The BE1- IPS100 was replaced by the BE1-11i on later serial numbers.Note: Either UMR can be programmed in the field from the front panel or by a laptop. Either BestComms BE1-IPS-100 software or BestComms+ BE1-11i software must be used. Both versions of the software are available from the Basler website at "www.basler.com".Refer to the "Instruction Manual for UMR BE1-IPS-100 Utility Multifunction Relay" or the "Instruction Manual for UMR BE1-11i Utility Multifunction Relay" for troubleshooting purposes. The publications can be found at the Basler website at "www.basler.com". BE1- IPS100 Settings
Illustration 1 g02158308
Illustration 2 g02158405
Illustration 3 g02158401
Illustration 4 g02158395
Illustration 5 g02158404
Illustration 6 g02158309
Illustration 7 g02158403
Illustration 8 g02158406
BE1-11i Settings
Illustration 9 g02192555
Illustration 10 g02192574
Illustration 11 g02193893
Illustration 12 g02194081
Illustration 13 g02194082
Illustration 14 g02194073
Illustration 15 g02194074
Illustration 16 g02193897
Illustration 17 g02193993
Illustration 18 g02194053
Illustration 19 g02194077
Illustration 20 g02194054
Illustration 21 g02194055
Illustration 22 g02194056