PLATE 4T7571 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7573     Link Bracket     3    
B     1P-2420     Transmission Repair Stand     1    
C     -     Threaded Rod
M10 - 1.5 by 250mm Long     2    Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01364830
Use Tooling (C) in order to help position control manifold (7). Install bolts (9) and bolts (8). Tighten bolts (9) and bolts (8) to a torque of 55 10 N m (41 7 lb ft).
Connect harness assemblies (10) .
Illustration 2 g01364803
If necessary, install filter assembly (6) and the O-ring seal. Refer to Operation and Maintenance Manual, "Oil Filter (Transmission) - Replace".
Install the screen and magnetic filter (5) into control manifold (6). Position O-ring seal (4) and cover (3) to control manifold (6). Install bolts (2). Tighten bolts (2) to a torque of 28 7 N m (21 5 lb ft).
Illustration 3 g01364812
Attach Tooling (A) and a suitable lifting device to transmission (1). The weight of transmission (1) is approximately 340 kg (750 lb). Use Tooling (A) and the suitable lifting device in order to remove transmission (1) from Tooling (B) .