AVSPARE.COM
parts catalog

PLATE AS-LH 4Z8767 - Caterpillar



4Z8767 PLATE AS-LH Caterpillar parts PLATE
Rating:
81
Alternative (cross code) number:
CA4Z8767
4Z-8767
4Z8767
Caterpillar 4Z8767 PLATE AS-LH
Weight: 1 pounds 0 kg.

Buy PLATE AS-LH 4Z8767 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 8 g00702583
Use two people in order to remove ring gear (15) from housing (16). The weight of ring gear (15) is approximately 29 kg (65 lb).
Illustration 9 g00702584
Remove spacer (17) from carrier assembly (18).
Illustration 10 g00702596
Use Tooling (A) to remove retaining ring (19).
Illustration 11 g01338951
Remove carrier assembly (18) from the housing. The weight of carrier assembly (18) is approximately 25 kg (55 lb).
Illustration 12 g00702640
Drive roll pin (20) into shaft (21). Remove shaft (21).
Illustration 13 g00702648
Disassemble the gear assembly, as follows: washer (22), bearing (23), gear (24), bearing (25), and washer (26). Remove roll pin (20) from shaft (21).
Repeat Step 13 through Step 14 for the remaining gear assemblies.
Illustration 14 g01339732
Remove bolts (27) from the housing.
Illustration 15 g01339903
Illustration 16 g01339833
Attach Tooling (B) and a suitable lifting device in order to remove housing (28). The weight of housing (28) is approximately 68 kg (150 lb). If shaft assembly (29) is stuck in housing (28) install Tooling (C) in order to remove shaft assembly (29).
Illustration 17 g01338949
Illustration 18 g01339781
Illustration 19 g01339877
Use Tooling (A) in order to install retaining ring (19). Attach a suitable lifting device to shaft assembly (29). The weight of shaft assembly (29) is approximately 45 kg (100 lb). Position shaft assembly (29) onto Tooling (E). Install Tooling (D).
Position Tooling (E) and shaft assembly (29) as a unit into a suitable press. The weight of Tooling (E) and the shaft assembly (29) is approximately 93 kg (205 lb). Use Tooling (A) in order to remove retaining ring (19). Remove bearings (30) and spacer (31). Note: If excessive force is required to remove bearings, use Tooling (F) in order to remove the top bearing first.
Illustration 20 g01338948
Attach a suitable lifting device to Tooling (D) in order to remove cage (33) and Tooling (E). Remove cage (33) and Tooling (E) from shaft (32).
Illustration 21 g01340053
Remove O-ring seal (34). Remove lip seals (35).


Parts plate Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.