AVSPARE.COM
parts catalog

PLATE 4Z8775 - Caterpillar



4Z8775 PLATE Caterpillar parts PLATE
Rating:
86
Alternative (cross code) number:
CA4Z8775
4Z-8775
4Z8775
Caterpillar 4Z8775 PLATE
Weight: 3 pounds 1 kg.

Buy PLATE 4Z8775 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Illustration 10 g00703700
Use a deburring tool in order to remove the metal burr from the openings in the carrier. Install shaft (21) and the gear assembly into the carrier assembly. Drive roll pin (20) into shaft (21). Orient the split in roll pin (20) vertically to the carrier. Align the split in the roll pin to the top or to the bottom. Make a stake mark on each side of the roll pin hole in the carrier. Each stake mark should be approximately 2.25 0.75 mm (0.090 0.030 inch) from the outside diameter of the roll pin hole.
Repeat Step 8 through Step 9 for the remaining gear assemblies.
Illustration 11 g01338951
Install carrier assembly (18) into the housing. The weight of carrier assembly (18) is approximately 25 kg (55 lb).
Illustration 12 g00702596
Use Tooling (A) to install retaining ring (19).
Illustration 13 g00702584
Install spacer (17) into carrier assembly (18).
Illustration 14 g01340279
Illustration 15 g00702583
Apply Tooling (L) to the face of housing (16). Install Tooling (K) in order to help align the housing and the ring gear. Use two people in order to install ring gear (15) onto housing (16). The weight of ring gear (15) is approximately 29 kg (65 lb).
Illustration 16 g00702459
Install retaining ring (14) into the sun gear.
Illustration 17 g00702457
Install carrier (13) into the sun gear. Install retaining ring (11) into sun gear (12).
Illustration 18 g00703707
Assemble the gear assembly, as follows: washer (7), gear (8), bearing (9), and washer (10)
Illustration 19 g00702452
Illustration 20 g00703700
Use a deburring tool in order to remove the metal burr from the openings in the carrier. Install shaft (6) and the gear assembly into the carrier assembly. Drive roll pin (5) into shaft (6). Orient the split in roll pin (5) vertically to the carrier. Align the split in the roll pin to the top or to the bottom. Make a stake mark on each side of the roll pin hole in the carrier. Each stake mark should be approximately 2.25 0.75 mm (0.090 0.030 inch) from the outside diameter of the roll pin hole.
Repeat Step 17 through Step 18 for the remaining gear assemblies.
Illustration 21 g00702451
Install carrier assembly (2) into ring gear (4).
Illustration 22 g00702450
Install spacer (3).
Illustration 23 g00702449
Install sun gear (1) into carrier assembly (2). End By:
Install the swing motor and swing drive.


Parts plate Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.