PLATE & FILM GP 5009112 - Caterpillar

The following table lists the engine speed for each of the Throttle Switch positions.
Table 2
Throttle Switch Positions     Engine RPM    
1     800 (2) (3)    
2     1100    
3     1550    
4     1800 (4)    
5 (5)     1550 (6)
1800 (7)    
( 2 ) Low Idle
( 3 ) When the FNR is in forward or reverse or Steering is not equal to 0, the desired engine speed is 1050 rpm with the parking brake in the OFF position.
( 4 ) High Idle
( 5 ) Position 5 is "Fuel Economy Mode"
( 6 ) Power Train in Neutral or Parking Brake ON
( 7 ) ForwardNote: Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, secure and in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure. This procedure should not require entry into any enclosures that contain hazardous voltage components and should not require any hazardous voltage connections to be disconnected.When an area that contains hazardous voltage components must be entered for a service procedure, the "Safe Shutdown Procedure for Electric Drive Tractors" procedure must be performed before any enclosures that contain hazardous voltage components are opened or before any hazardous voltage connectors are disconnected. Refer to the Troubleshooting, "Electrical Maintenance Guidelines" section of this manual. Perform the "Safe Shutdown Procedure for Electric Drive Tractors" procedure before any of the hazardous voltage areas are opened or before hazardous voltage connectors are disconnected.Note: The following test procedure may cause other diagnostic codes to be activated. Ignore these created diagnostic codes and clear the diagnostic codes when the problem has been corrected.Test Step 1. CHECK THE SWITCH
Turn the key switch disconnect switch and the disconnect switch to the ON position. DO NOT START THE ENGINE.
While observing the status of the active CID 2705 FMI 04 diagnostic code, disconnect the machine harness connector from the switch module connector.Expected Result:When the machine harness connector