PLATE & FILM GP 5081889 - Caterpillar

5081889 PLATE & FILM GP Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA5081889
508-1889
5081889

Buy PLATE & FILM GP 5081889 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme:

Caterpillar 5081889 Parts scheme PLATE & FILM GP

For full view, you need register

Information:

Removal Procedure
Start By:
Remove the fan. Refer to Disassembly and Assembly, "Fan - Remove and Install" for the correct procedure.
Remove the crankshaft pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Remove" for the correct procedure.
Remove the engine oil pan plate. Refer to Disassembly and Assembly, "Engine Oil Pan Plate - Remove" for the correct procedure.
If the engine has an accessory drive, remove the accessory drive. Refer to Disassembly and Assembly, "Accessory Drive - Remove and Install" for the correct procedure.
Remove the water pump. Refer to Disassembly and Assembly, "Water Pump - Remove" for the correct procedure.
Remove the timing gears. Refer to Disassembly and Assembly, "Gear Group (Front) - Remove and Install" for the correct procedure.
Remove the fuel injection pump. Refer to Disassembly and Assembly, "Fuel Injection Pump - Remove" for the correct procedure.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g03430098
Remove bolts (2) that secure bypass tube (1) to front housing (3).
Remove bypass tube (1) from the cylinder head. Remove O-ring (4) and O-ring (5) from bypass tube (1).
Illustration 2 g03378762
Remove bolts (6), bolts (7), and bolts (8) from front housing (3). Note: The bolts are different lengths. Note the positions of the different length bolts.
Remove front housing (3) from the cylinder block.
Remove gasket (10).
If necessary, follow Step 6.a through Step 6.b in order to remove bearing (9) from housing (3).
Place housing (3) onto a suitable support.
Use a suitable tool in order to press bearing (9) out of housing (3).
Illustration 3 g03378764
Remove thrust washer (11) from the cylinder block.