PLATE AS-SIDE 5111341 - Caterpillar

Earlier models have retainers in place of the locknuts and washers. It is necessary to destroy the retainers to remove them.12. Remove pin (17) from the latch assembly.13. Remove lever (18). Remove latch assembly (19) and spring (20).14. If necessary, because of wear or damage, remove cap (21) from the lever.
Spring force will be released when springs are disconnected from the housing assembly.
15. Use a screwdriver to disconnect springs (22) from the housing assembly.16. Remove bolts (24) and lockwashers from each side of the link assembly. Remove link assembly (23) and springs (22) from the suspension group. 17. Remove retainers (25). Remove links (26) from the link assembly. It is necessary to destroy retainers (25) to remove them.18. Remove pin (27). Remove knob assembly (28) and spacer (29) from the shaft.19. Use a screwdriver to remove fasteners (30) from the suspension group. Remove boot (31).20. Remove indicator (32) and pin (33).
Housing assembly is under spring force. Put a downward force on the housing assembly slowly until the spring force on it is released.
21. Remove nuts (34). Remove shafts (35). 22. Remove four bearings (36) from the arm assembly.23. Remove sleeves (38) and cable (37) from the arm assembly.24. Remove gear assembly (39) and washer from the housing assembly.25. Remove pin (40) from the gear assembly. Remove plate assembly (41).26. Remove gear assembly (42) from the housing assembly. 27. Remove bolts and nuts (44). Remove bracket (43).28. Remove housing assembly (45) and two blocks from the arm assembly.29. Remove arm assembly (46) and two blocks from the adjuster group.30. Remove spring (47).31. Remove bolt and nut (49). Remove shock absorber (48). 32. Remove the bearings from each end of the shock absorber.33. Remove bolt (51) from the bottom of the plate. Remove housing assembly (50) from the plate.34. Remove retainers (55). Remove roller assemblies (56). It is necessary to destroy retainers (55) to remove them.35. Remove pad (57) from the housing assembly.36. Remove retainers (59). Remove rods (52), springs (53), latch assemblies (54) and lever (58). It is necessary to destroy retainers (59) to remove them.ASSEMBLE SEAT
1. Install lever (3), latch assemblies (1), rods (2), and springs (4) on the housing. Install the retainers that hold the lever and latch assemblies to the housing. Use a piece of pipe with a 5/8" (15.9 mm) inside diameter approximately 5" (12.7 cm) long to install retainers. 2. Put 5H2471 General Purpose adhesive on the housing assembly and install pad (5).3. Put roller assemblies (7) in position on the housing assembly. Make sure the swaged side (raised metal) (8) of the roller is away from the lower housing assembly.4. Install the retainers (6) that hold the roller assemblies. Use a piece of pipe with a 5/8" (15.9 mm) inside diameter approximately 5 in. (12.7 cm) long to install the retainers.5. Put plate (9) in position on the housing assembly (10). Install the bolt that holds the housing assembly on the plate. Tighten the bolt to a torque of 50 5