PLATE AS 5115862 - Caterpillar

Illustration 17 g01473997
Move screed lift switch (4) to the RAISE position. Completely lift the screed.
Illustration 18 g01510335
Engage screed lock mechanism (5) on both sides of the machine.
Move screed lift switch (4) to the FLOAT position.Note: The screed lift switch on the inactive instrument panel must also be in the FLOAT position in order to lower the screed.
Illustration 19 g01510336
Move right screed extend switch (7) to the EXTEND position. Release the switch when the right screed extender is fully extended.
Move left screed extend switch (6) to the EXTEND position. Release the switch when the left screed extender is fully extended.
Illustration 20 g01510338
Move throttle control switch (8) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
After the engine reaches low idle, move engine start switch (9) to the OFF position.
Move screed lift switch (4) to the HOLD position.
Move engine start switch (9) to the ON position. Do not start the engine.
Illustration 21 g01514027
Press home key (10) .
Illustration 22 g01514027
Press down key (11) until "Service" is highlighted on the display screen.
Press OK key (12) .
Illustration 23 g01514028
Press down key (11) until "Calibrations" is highlighted on the display screen.
Press OK key (12) .
Illustration 24 g01514050
Press down key (11) until "Right Paddle Sensor" is highlighted on the display screen.
Press OK key (12) .
Press OK key (12) in order to begin the calibration.
Illustration 25 g01514053
Press OK key (12) .
Illustration 26 g01514055
Illustration 27 g01514056
Hold right paddle (13) in the full OFF position at approximately 45 degrees. Press OK key (12) .
Illustration 28 g01514058
Illustration 29 g01514059
Place right paddle (13) in the full ON position. This should be straight down. Press OK key (12) .
Illustration 30 g01514064
The display should now read "CALIBRATION COMPLETE". Push back key (14) in order to return to the calibration screen.
Push home key (10) in order to exit the calibration screen.
Move engine start switch (9) to the OFF position.