PLATE & FILM GP 5233113 - Caterpillar

Installation of the Blade Group and Strut Assembly
Table 10
275-5881 Extension Tube Gp
Item Qty Part Number Part Name
33 1 275-5881 Extension Tube Gp
Table 11
275-5875 Blade Gp
Item Qty Part Number Part Name
34 1 275-5875 Blade Gp
Illustration 37 g02677396
Rear view
(11) 331-9951 Bolt
Illustration 38 g02677516
Front view
(1) 4B-5327 Washer
(12) 299-3401 Hex Slotted Nut
(13) 3B-4647 Cotter Pin
Attach the blade group (34) to the mast using bolt (11), and washer (1), nut (12), and cotter pin (13).
Illustration 39 g02677537
Area (J)
Illustration 40 g02677538
Close up of area (J)
Attach the vertical link of the link group to the ear assembly on the backside of the blade using the existing hardware.
Illustration 41 g02677639
(33) 275-5881 Extension Tube Gp
Illustration 42 g02721047
(33) 275-5881 Extension Tube Gp
(89) 6V-7676 Nut
(95) 8T-0672 Bolt
Install extension tube (33) to the blade using existing hardware.
Illustration 43 g02677736
(K) Clevis
Pin the end with the cable attached to the 337-2921 Brace Support Gp using existing hardware.
Attach the cable clevis to the brace support group.Note: The cable clevis must be attached to the rear strut support brace group. This cable restricts the travel of the strut group and blade when the shear pin has been sheared.
Illustration 44 g02677765
Right side view
Illustration 45 g02677767
Bottom view
Torque all fasteners to proper specification. Ensure that the shear-bolt has been fastened with two of 9S-8752 Full Nut.Note: Maintain a supply of 3/8 inch x 4.0 inch grade 8 capscrew, Caterpillar number 8S-9191 Bolt, to use as shear pin. Use only a 3/8 inch diameter grade 8 capscrew as shear pin. Any other type of material or different diameter will not provide the protection required from extreme shock loads. Using any other type of shear pin could result in damage to the snow wing and/or Motor Grader.