PLATE AS (SEM) 5367762 - Caterpillar

Removal Procedure
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Illustration 1 g00778437
Remove four bolts (1) and the four washers in order to disconnect tube assembly (2) from torque converter outlet relief valve (3). Note: Not all of bolts (1) will be completely removed because of an impending problem with a hose.
Illustration 2 g00778462
Disconnect hose assembly (4) from torque converter outlet relief valve (3).
Illustration 3 g00778498
Remove nut (8), the washer, and wire (7).
Remove three bolts (5), the three washers, and clip (6) with the wiring. Remove the torque converter outlet relief valve from the machine. Remove the O-ring seals from the torque converter outlet relief valve.