PLATE-SIDE 5410981 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 425-0952 Chock 2
B 504-9790 Lift Gp (60 Hz)(1) 2
OR
504-9792 Lift Gp (50 Hz)(2) 2
C 5P-7311 Chain Puller 1
(1) High-Voltage (480V) Low-Voltage (240V)
(2) High-Voltage (400V) Low-Voltage (200V)Start By:
Remove the drive shaft.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01349206
Use Tooling (A) to chock the front wheels.
Illustration 2 g06275129
Position Tooling (B) as shown in Illustration 2. Raise the rear of the machine until the rear wheels are off the ground. Refer to Tool Operating Manual , NEHS1303, "Lift Group (Stand - 25 Ton)" for more information on Tooling (B).
Refer to Operation and Maintenance Manual, "Tandem Drive Oil - Change" for the correct draining and filling procedures. Drain the tandem drive oil.
Illustration 3 g01348992
Remove walkway (1).
Illustration 4 g01348998
Remove bolts (2), cover (3), and gasket (4). Discard gasket (4). Remove bolts (5), cover (6), and gasket (7). Discard gasket (7).
Illustration 5 g01349006
Install Tooling (C) to secure the drive chain. Remove cotter pins (8) and disconnect master link (9).
Illustration 6 g01349029
Use a suitable lifting device to remove drive chain (10). The weight of drive chain (10) is approximately 32 kg (70 lb).
Repeat this procedure for the remaining drive chain.Drive Chain - Install
Install drive chain (10) in the reverse order of removal.
Tighten bolts (5) to a torque of 27 7 N m (20 5 lb ft).
Tighten bolts (2) to a torque of 27 7 N m (20 5 lb ft).