PLATE 5H5873 - Caterpillar

1. Remove pin (5).2. Move signal plate (1) to the LIFT KICKOUT position [maximum clockwise position of lever (3)].3. Move lift lever (6) (counterclockwise) to the RAISE detent.4. Adjust the length of rod assembly (7) until the pin holes of lever (4) and the rod assembly are in alignment.5. Make rod assembly (7) shorter by four turns. Put lift lever (6) in the spring-centered position and install pin (5).6. Raise the bucket to the desired height.7. Make mark (8) on the lift arms opposite the high point of pin (2). [Pin (2) is part of lever (3)].8. Lower the bucket.9. Move signal (1) until the lobe (high point of the signal plate) is in alignment with mark (8) on the lift arm.10. Tighten the bolts that hold signal plate (1) in position.