PLATE BLOCKER 5P1751 - Caterpillar

1. Remove four truss head screws (1) and the washers from headliner (2). Lower headliner (2), on the hinges, to expose the window wiper motor. 2. Loosen bolt (5). Disconnect wiring harness (4), to window wiper motor (6), at the electrical connection. Remove three bolts (3) and the hard washers from window wiper motor (6). Remove window wiper motor (6) from the bracket assembly. The following steps are for the installation of the window wiper motor. Check all components for wear or damage and replace if necessary. Apply 1U-6396 O-ring Compound to all O-ring seals prior to installation, if applicable.3. Put window wiper motor (6) on the bracket assembly. Install three bolts (3) and the hard washers in window wiper motor (6). Connect wiring harness (4) to window wiper motor (6) at the electrical connector. Tighten bolt (5).4. Raise headliner (2) on the hinges. Install four truss head screws (1) and the washers.