PLATE, IDENTIFICATION 5P3705 - Caterpillar

Table 2
Reference for 390D    
Stick Lines Gp    Hose As    Stick Ar    Stick Length    Stick Family    Hose As Angle    Reference Point    
338-6166     338-6158     303-2691 319-9212     R5.5m     Reach-Long     45 +/- 3 degrees     E    
338-6167     338-6159     303-2692 319-9213     R4.4m     Reach-Medium     60 +/- 3 degrees     D    
338-6169     338-6157     303-2694 303-2696     G3.4m     General-Medium     30 +/-3 degrees     C    
338-6170     338-6156     303-2695     R2.9m     Reach-Short     10 +/- 3 degrees     B    
338-6171     338-6171     303-2697     M2.9m     Mass-Short     0 degrees     A    
Illustration 2 g02973878
374D
Illustration 3 g02974016
390D
If a non-Caterpillar front linkage will be installed, such as a super long reach from an external supplier, it will be necessary to configure the machine for the non-Caterpillar front end. Refer to 374D and 390D Excavators Machine Electronic Control System, KENR8955, "Testing and Adjusting, Systems Operation", "Troubleshooting".
After installation of the front linkage/bucket/quick coupler, it will be necessary to calibrate the valves before any operation of the machine is done. Perform the boom and stick regeneration valve calibration, the boom lowering control valve calibration (if equipped) and the all valve calibration. Refer to 374D and 390D Excavators Machine Electronic Control System, KENR8955, "Testing and Adjusting, Systems Operation", "Troubleshooting".