PLATE 5R9950 - Caterpillar

ACTION REQUIRED
****Parts Stock ****
Remove all 217-2610 Turbo Oil Supply lines from dealer parts stock.
****Affected Product****
Replace the turbo oil supply line. Refer to the attached rework procedure.
SERVICE CLAIM ALLOWANCES
****Parts Stock****
Submit one claim for all parts removed from dealer parts stock.
****Affected Product****
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
0-6000 hrs,
0-36 mo 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 1.5-hour job
PARTS DISPOSITION
****Parts Stock****
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
****Affected Product****
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
Rework Procedure
Refer to Image 1.1.1
1. Remove the two 1A-2029 Oil Tube Mounting Bolts, and the old gasket (1).
2. Undo the compression Nut (2).
3. Remove the oil supply tube (3).
4. Remove the 148-8315 Connector (2).
5. If your machine has an 8C-6873 (pipe thread fitting) at location (2) instead of the 148-8315, Re-install the 8C-6873 fitting into the filter base, then install the 8C-7563 adapter as shown in Image 1.1.2 and skip to step 8.
Image1.1.1
Image1.1.2
Refer to Image 1.2.1 & Image 1.2.2
6. Assemble the 6V-9003 Elbow with the 2M-9780 and 7J-9108 O-rings.
2M-9780 goes on the oil filter base end, and 7J-9108 goes on the tube end.
7. Install the elbow (4), and orient it 30 degrees above the horizontal.
8. Thread the new 312-7982 Oil Supply Line onto the elbow and leave it loose.
9. Secure the top of the new supply line with the 2 5S-7383 Bolts (5), gasket (7N-8875) and torque to 47 +/- 9 Nm (35 +/- 7 lb ft).
10. Tighten the compression nut on the supply line to a torque of 80 + 8 Nm (60 + 6 lb ft).
Image1.2.1
Image1.2.2