5S0553 PLATE Caterpillar parts
992, D348
Rating:
Alternative (cross code) number:
CA5S0553
5S-0553
5S0553
CA5S0553
5S-0553
5S0553
Weight: 1 pounds 0 kg.
MARINE ENGINE, WHEEL LOADER,
Compatible equipment models: 5S0553:
Number on catalog scheme:
34
For full view, you need register
Information:
Caterpillar Products:
AllDescription of Change: The new radio software is now used on all PL522 and 523 radio devices. The new software (PROD_REL- 4.0.2) contains the following enhancements:
Corrected issue in previous software version (PROD_REL- 4.0.1) where input events on digital inputs 6 and 7 are swapped on radio device
Corrected issue in which SIM status was intermittently set to an incorrect status of "Not Ready"
Added wakeup override support in which the device will holdoff shutdown if ignition is off but wakeup override signal is set
Corrected issue in which digital and ignition events were getting missed
Improved boot-up to cell connection time
Corrected issue in which personality reports were missing data
Added improvements to Radio/Gateway connection
Added significant web server access time improvements
Added support for "Number of SIM PIN Entry Attempts Remaining"
Added Site Entry and Exit reporting when ignition is off
Corrected issue in which service meter hours (SMH) would not accrue correctly after Engine ON, following an Engine OFF where the device did not go into low-power mode
Corrected issue of slow-memory leaks causing device restart after several days
Added protection against loss of system log after power cut to every 60 seconds
Increased engineering log storage from 3mb to 5mb
Added serial port configuration to BIT config once-a-day report
Added various Cat ET cellular status improvements
Personality report is now sent out after all cell parameters have been receivedAdaptable To: The new software PROD_REL - 4.0.2 replaces the old software PROD_REL - 4.0.1 or older. The new radio software is adaptable to all Caterpillar products using a Product Link 522/523 Radio.Note: The PL522/523 has to be fully updated by updating both the gateway and the radio. The PL522/523 gateway can be updated via Cat ET. The PL522/523 radio is updated Over-the-Air (OTA) only. There is no capability for updating the PL522 or 523 radio Over-the-Wire (OTW) with Cat ET or WinFlash. Upon the release, firmware version PROD_REL- 4.0.2 will be available by request through VisionLink Support ONLY, and it will not be available in SISweb.
AllDescription of Change: The new radio software is now used on all PL522 and 523 radio devices. The new software (PROD_REL- 4.0.2) contains the following enhancements:
Corrected issue in previous software version (PROD_REL- 4.0.1) where input events on digital inputs 6 and 7 are swapped on radio device
Corrected issue in which SIM status was intermittently set to an incorrect status of "Not Ready"
Added wakeup override support in which the device will holdoff shutdown if ignition is off but wakeup override signal is set
Corrected issue in which digital and ignition events were getting missed
Improved boot-up to cell connection time
Corrected issue in which personality reports were missing data
Added improvements to Radio/Gateway connection
Added significant web server access time improvements
Added support for "Number of SIM PIN Entry Attempts Remaining"
Added Site Entry and Exit reporting when ignition is off
Corrected issue in which service meter hours (SMH) would not accrue correctly after Engine ON, following an Engine OFF where the device did not go into low-power mode
Corrected issue of slow-memory leaks causing device restart after several days
Added protection against loss of system log after power cut to every 60 seconds
Increased engineering log storage from 3mb to 5mb
Added serial port configuration to BIT config once-a-day report
Added various Cat ET cellular status improvements
Personality report is now sent out after all cell parameters have been receivedAdaptable To: The new software PROD_REL - 4.0.2 replaces the old software PROD_REL - 4.0.1 or older. The new radio software is adaptable to all Caterpillar products using a Product Link 522/523 Radio.Note: The PL522/523 has to be fully updated by updating both the gateway and the radio. The PL522/523 gateway can be updated via Cat ET. The PL522/523 radio is updated Over-the-Air (OTA) only. There is no capability for updating the PL522 or 523 radio Over-the-Wire (OTW) with Cat ET or WinFlash. Upon the release, firmware version PROD_REL- 4.0.2 will be available by request through VisionLink Support ONLY, and it will not be available in SISweb.
Caterpillar parts catalog:
Parts plate Caterpillar catalog:
1140, 1160, 12E, 14E, 1673, 1673B, 1673C, 1676, 16G, 215, 245, 3208, 3304, 3306, 3406, 3412, 777, 824, 941, 950, 955K, 966C, 977H, D320A, D330A, D334, D336, D348, D4D, D6C, D7F, G3304
120G, 12F, 12G, 130G, 140, 141, 14E, 14G, 153, 16, 163, 16G, 172, 173B, 183, 183B, 184, 191, 193, 30/30, 416, 416B, 426B, 428, 428B, 438B, 446, 46, 508, 515, 517, 518, 525, 525D, 527, 528, 535D, 545D,...
3412, 772, 777, D348, D379B, G379, G399
16, 1693, 245, 3406, 3408, 3412, 3508B, 3512, 594, 621, 627, 631C, 631D, 633C, 633D, 637D, 651, 651E, 657B, 657E, 769C, 772, 824B, 966D, 977K, 988, 988B, 992C, D10, D342, D342C, D348, D379A, D379B, D3...
120G, 120H, 120H ES, 120H NA, 120K, 120K 2, 120M, 120M 2, 12E, 12G, 12H, 12H ES, 12H NA, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 130G, 135H, 135H NA, 140G, 140H, 140H ES, 140H NA, 140K, 140K 2, 140M, 140M ...
16, 1693, 3406, 594, 631C, 657, 657B, 666, 769, 777, 824B, 826B, 834, 983, 988, 992, D342C, D343, D348, D8H, D9G, D9H, G343
16, 1693, 3406, 594, 631C, 657, 657B, 666, 769, 777, 824B, 826B, 834, 983, 988, 992, D342C, D343, D348, D8H, D9G, D9H, G343
16, 1693, 3406, 594, 631C, 657, 657B, 666, 769, 777, 824B, 826B, 834, 983, 988, 992, D320A, D342C, D343, D348, D4D, D8H, D9G, D9H, G343
215, 215B, 225, 229, 235, 235B, 235D, 245, 245B, 24H, 24M, 5110B, 5130, 5130B, 5230, 5230B, 528, 589, 621, 621B, 621E, 621F, 621G, 621R, 623E, 623F, 623G, 627B, 627E, 627F, 627G, 631C, 631E, 631G, 633...
594H, 657B, 772, 777, 834, 992, D8H, D8K, D9G, D9H
621B, 621E, 621F, 621G, 621H, 621K, 623E, 623F, 623G, 623H, 623K, 623K LRC, 627B, 627E, 627F, 627G, 627H, 627K, 627K LRC, 631E, 631G, 633E II, 637D, 637E, 637G, 641B, 650B, 651E, 657B, 657E, 657G, 666...
834B, 836, 972G, 980G, 980G II, 988B, 988F, 988F II, 988G, 992, D44B, D550B
2N4369
PLATE
3606, 3608, D379A, D379B, D398, D398A, D398B, D399, G379, G398, G399
3606, 3608, D379A, D379B, D398, D398A, D398B, D399, G379, G398, G399
2S3147
PLATE
D348
D348
8L4174
PLATE ASSEM.
1673C, 1674, 1676, 1693, 3304, 3306, 627, 657B, D343, D379, D398, D399, D6C
1673C, 1674, 1676, 1693, 3304, 3306, 627, 657B, D343, D379, D398, D399, D6C
1N8486
PLATE
D399
D399
777, 992, D10, D348
6L7541
PLATE
3181
3181
1H9437
PLATE
D320A, D336, D342C, D343
D320A, D336, D342C, D343
4L7523
PLATE ASSEM.
D342C, D343, D353C, G342C
D342C, D343, D353C, G342C
7L0130
PLATE
D348, D398
D348, D398
D348, D398
D348, D398
1N9907
PLATE
3192, D379, D379A, D379B, D398, D398A, D398B, D399
3192, D379, D379A, D379B, D398, D398A, D398B, D399